po.4接火焰传感器输出代码
时间: 2023-10-02 15:09:56 浏览: 51
以下是PO.4接火焰传感器输出的代码示例,仅供参考:
```c
#include "stm32f10x.h"
#define FIRE_SENSOR_PIN GPIO_Pin_4
#define FIRE_SENSOR_PORT GPIOA
void init_fire_sensor(void)
{
/* 初始化GPIOA口 */
GPIO_InitTypeDef GPIO_InitStructure;
RCC_APB2PeriphClockCmd(RCC_APB2Periph_GPIOA, ENABLE);
GPIO_InitStructure.GPIO_Pin = FIRE_SENSOR_PIN;
GPIO_InitStructure.GPIO_Mode = GPIO_Mode_IN_FLOATING;
GPIO_Init(FIRE_SENSOR_PORT, &GPIO_InitStructure);
}
int read_fire_sensor(void)
{
return GPIO_ReadInputDataBit(FIRE_SENSOR_PORT, FIRE_SENSOR_PIN);
}
int main(void)
{
init_fire_sensor();
while(1)
{
int fire_detected = read_fire_sensor();
if(fire_detected)
{
/* 火焰检测到了 */
}
else
{
/* 火焰没有检测到 */
}
}
}
```
在上面的代码中,首先需要初始化PO.4口为浮空输入模式,然后使用GPIO_ReadInputDataBit函数读取PO.4口的电平值来确定是否检测到了火焰。需要注意的是,PO.4口的电平值为0表示火焰未检测到,为1表示火焰已经检测到。在具体的应用中,还需要根据实际情况进行一些电路设计和程序优化。
相关推荐
![rar](https://img-home.csdnimg.cn/images/20210720083606.png)
![](https://csdnimg.cn/download_wenku/file_type_ask_c1.png)
![](https://csdnimg.cn/download_wenku/file_type_ask_c1.png)
![](https://csdnimg.cn/download_wenku/file_type_ask_c1.png)
![](https://csdnimg.cn/download_wenku/file_type_ask_c1.png)
![](https://csdnimg.cn/download_wenku/file_type_ask_c1.png)
![](https://csdnimg.cn/download_wenku/file_type_ask_c1.png)
![](https://csdnimg.cn/download_wenku/file_type_ask_c1.png)
![](https://csdnimg.cn/download_wenku/file_type_ask_c1.png)
![](https://csdnimg.cn/download_wenku/file_type_ask_c1.png)
![](https://csdnimg.cn/download_wenku/file_type_ask_c1.png)
![](https://csdnimg.cn/download_wenku/file_type_ask_c1.png)
![](https://csdnimg.cn/download_wenku/file_type_ask_c1.png)
![](https://csdnimg.cn/download_wenku/file_type_ask_c1.png)
![](https://csdnimg.cn/download_wenku/file_type_ask_c1.png)
![](https://csdnimg.cn/download_wenku/file_type_ask_c1.png)