仿真遇到Could not stop Cortex-M device! please check the JTAG cable
时间: 2023-10-20 09:30:34 浏览: 42
这个问题通常意味着仿真器无法与目标设备进行通信。导致这个问题出现的原因可能有很多,比如JTAG电缆连接不良、目标设备电源异常等等。您可以尝试以下措施:
1.检查JTAG电缆是否连接好,重新插拔一遍试试;
2.检查目标设备电源是否正常,是否有正确的电压和电流;
3.尝试使用其他仿真器或者目标设备进行测试,看看问题是否依旧存在;
4.检查仿真器的驱动程序和配置是否正确,是否需要更新或重新安装驱动程序;
5.尝试使用其他仿真软件进行仿真,看看问题是否依旧存在。
如果以上措施都无法解决问题,建议您联系仿真器或目标设备的供应商或制造商,获取更详细的技术支持。
相关问题
Could not stop Cortex-M device! please check the JTAG cable
This error message typically indicates an issue with the JTAG cable connection to your Cortex-M device. Here are a few potential solutions:
1. Check that the JTAG cable is securely connected to both the device and the debugger.
2. Verify that the JTAG cable is the correct type for your device.
3. Ensure that the device is powered on and that the power supply is stable.
4. Try resetting the device and restarting the debugger.
5. If none of these steps work, try replacing the JTAG cable with a new one.
If you are still experiencing issues after trying these solutions, it may be helpful to consult the documentation for your specific device and debugger, or reach out to the manufacturer for additional support.
Could not stop Cortex-M device!Please check the JTAG cable.
问题的原因可能是JTAG连接线有问题。[1]解决方法是检查JTAG连接线是否连接良好。另外,还有一些其他可能的原因,比如烧录过程中出现了错误,或者目标设备上的复位电路有问题。[2][3]如果检查JTAG连接线没有问题,可以尝试重新启动MDK或使用串口下载进行擦除。然而,需要注意的是,这个问题的解决方法可能因情况而异,所以并不能保证以上方法适用于所有情况。