写出stm32控制hc-05蓝牙程序配置

以下是将STM32与HC-05蓝牙模块连接并进行数据传输的程序配置：

#include "stm32f10x.h"

int main(void)
{
  GPIO_InitTypeDef GPIO_InitStructure;
  USART_InitTypeDef USART_InitStructure;

  //使能时钟
  RCC_APB2PeriphClockCmd(RCC_APB2Periph_GPIOA | RCC_APB2Periph_USART1, ENABLE);

  //配置PA9为复用功能推挽输出
  GPIO_InitStructure.GPIO_Pin = GPIO_Pin_9;
  GPIO_InitStructure.GPIO_Speed = GPIO_Speed_50MHz;
  GPIO_InitStructure.GPIO_Mode = GPIO_Mode_AF_PP;
  GPIO_Init(GPIOA, &GPIO_InitStructure);

  //配置PA10为输入
  GPIO_InitStructure.GPIO_Pin = GPIO_Pin_10;
  GPIO_InitStructure.GPIO_Mode = GPIO_Mode_IN_FLOATING;
  GPIO_Init(GPIOA, &GPIO_InitStructure);

  //USART1配置
  USART_InitStructure.USART_BaudRate = 9600;
  USART_InitStructure.USART_WordLength = USART_WordLength_8b;
  USART_InitStructure.USART_StopBits = USART_StopBits_1;
  USART_InitStructure.USART_Parity = USART_Parity_No;
  USART_InitStructure.USART_HardwareFlowControl = USART_HardwareFlowControl_None;
  USART_InitStructure.USART_Mode = USART_Mode_Rx | USART_Mode_Tx;
  USART_Init(USART1, &USART_InitStructure);

  //开启USART1
  USART_Cmd(USART1, ENABLE);

  while(1)
  {
    //等待接收数据
    while(USART_GetFlagStatus(USART1, USART_FLAG_RXNE) == RESET);
    uint8_t data = USART_ReceiveData(USART1);

    //发送数据
    USART_SendData(USART1, data);
    while (USART_GetFlagStatus(USART1, USART_FLAG_TXE) == RESET);
  }
}

注意：以上程序只是将STM32和HC-05连接并进行数据传输，具体使用应根据实际情况进行修改。