来一份stm32 f103c8t6 rc522串口测试代码
时间: 2024-03-20 09:36:57 浏览: 16
当然可以!下面是一份基于STM32F103C8T6和RC522模块的串口测试代码示例:
```c
#include "stm32f10x.h"
#include "rc522.h"
void USART1_Init(void)
{
GPIO_InitTypeDef GPIO_InitStructure;
USART_InitTypeDef USART_InitStructure;
RCC_APB2PeriphClockCmd(RCC_APB2Periph_USART1 | RCC_APB2Periph_GPIOA, ENABLE);
// 配置USART1的引脚
GPIO_InitStructure.GPIO_Pin = GPIO_Pin_9; // USART1_TX
GPIO_InitStructure.GPIO_Mode = GPIO_Mode_AF_PP;
GPIO_InitStructure.GPIO_Speed = GPIO_Speed_50MHz;
GPIO_Init(GPIOA, &GPIO_InitStructure);
GPIO_InitStructure.GPIO_Pin = GPIO_Pin_10; // USART1_RX
GPIO_InitStructure.GPIO_Mode = GPIO_Mode_IN_FLOATING;
GPIO_Init(GPIOA, &GPIO_InitStructure);
// 配置USART1
USART_InitStructure.USART_BaudRate = 9600;
USART_InitStructure.USART_WordLength = USART_WordLength_8b;
USART_InitStructure.USART_StopBits = USART_StopBits_1;
USART_InitStructure.USART_Parity = USART_Parity_No;
USART_InitStructure.USART_HardwareFlowControl = USART_HardwareFlowControl_None;
USART_InitStructure.USART_Mode = USART_Mode_Rx | USART_Mode_Tx;
USART_Init(USART1, &USART_InitStructure);
// 使能USART1
USART_Cmd(USART1, ENABLE);
}
void USART1_SendChar(char ch)
{
while (USART_GetFlagStatus(USART1, USART_FLAG_TXE) == RESET)
;
USART_SendData(USART1, (uint8_t)ch);
}
int main(void)
{
uint8_t uid[5];
RCC_APB2PeriphClockCmd(RCC_APB2Periph_GPIOC, ENABLE);
RC522_Init();
USART1_Init();
while (1)
{
if (RC522_CheckCard(uid) == MI_OK)
{
USART1_SendChar('[');
for (int i = 0; i < 5; i++)
{
USART1_SendChar(uid[i]);
}
USART1_SendChar(']');
}
}
}
```
这段代码使用了STM32F103C8T6的USART1串口与RC522模块进行通信。在主循环中,通过调用`RC522_CheckCard`函数检测是否有卡片靠近RC522模块,如果有,则通过USART1串口将卡片的UID发送出去。
请注意,以上代码仅为示例,具体的硬件连接和其他配置可能需要根据你的实际情况进行调整。