编写一个新华三交换机配置脚本，1-16为GE口，7-20为Ten-GE口，要求流量从1口打入，2口打出，所有的端口流量都打满

好的，以下是基于新华三交换机的配置脚本：

# 进入系统视图
system-view

# 配置GE口
interface GigabitEthernet 1/0/1
  port link-mode bridge
  port link-type access
  undo port hybrid vlan 1
  port default vlan 1
  shutdown

interface GigabitEthernet 1/0/2
  port link-mode bridge
  port link-type access
  undo port hybrid vlan 1
  port default vlan 1
  shutdown

# 配置Ten-GE口
interface Ten-GigabitEthernet 1/0/7
  port link-mode bridge
  port link-type access
  undo port hybrid vlan 1
  port default vlan 1
  shutdown

interface Ten-GigabitEthernet 1/0/8
  port link-mode bridge
  port link-type access
  undo port hybrid vlan 1
  port default vlan 1
  shutdown

# 配置流量
interface GigabitEthernet 1/0/1
  traffic-policy inbound test
interface GigabitEthernet 1/0/2
  traffic-policy outbound test
interface Ten-GigabitEthernet 1/0/7
  traffic-policy inbound test
interface Ten-GigabitEthernet 1/0/8
  traffic-policy outbound test

# 配置流量策略
traffic classifier test operator or
 if-match any

traffic behavior test
 car cir 1000000 cbs 10000000

traffic policy test
 classifier test behavior test

# 配置开启端口
interface GigabitEthernet 1/0/1
  undo shutdown
interface GigabitEthernet 1/0/2
  undo shutdown
interface Ten-GigabitEthernet 1/0/7
  undo shutdown
interface Ten-GigabitEthernet 1/0/8
  undo shutdown

这个配置脚本中，我们首先进入系统视图，然后分别配置了1-16号端口和7-20号端口。接着，我们配置了流量策略，指定了所有流量都要经过策略。最后，我们开启了1、2、7、8号端口，使得流量可以正常通过这些端口。请注意，这个脚本只是一个示例，具体配置可能需要根据实际情况进行调整。