EIGRP 修改hello时间间隔
时间: 2023-08-11 11:20:09 浏览: 67
要修改 EIGRP 的 Hello 时间间隔,可以通过以下步骤完成:
1. 进入 EIGRP 进程配置模式:`router eigrp <AS号>`
2. 使用 `timers` 命令进入时间参数配置模式:`timers <active-time> <hold-time> <flush-time>`
3. 在时间参数配置模式中,使用 `hello` 命令修改 Hello 时间间隔:`hello <时间间隔>`
4. 退出时间参数配置模式:`exit`
5. 退出 EIGRP 进程配置模式:`exit`
6. 最后,保存配置:`write`
例如,如果要将 Hello 时间间隔修改为 10 秒,可以执行以下命令:
```
router eigrp 100
timers 5 15 60
hello 10
exit
exit
write
```
相关问题
怎么查看 Hello 时间间隔
要查看 EIGRP 接口的 Hello 时间间隔,可以使用 `show running-config` 命令或 `show interface` 命令。
使用 `show running-config` 命令可以查看当前配置的 EIGRP 进程,包括时间参数配置。例如:
```
show running-config | section eigrp
```
使用 `show interface` 命令可以查看接口的详细信息,包括 EIGRP 相关的配置信息,如路由协议、协议状态、Hello 时间间隔等。例如:
```
show interface <interface-name>
```
其中 `<interface-name>` 是接口的名称,如 `GigabitEthernet0/0/0`。
在 `show interface` 命令的输出中,可以查看 `Hello` 字段,该字段显示了 EIGRP 接口的 Hello 时间间隔。例如:
```
Internet address is 192.168.1.1/24
...
EIGRP-IPv4 Protocol for AS(100)
Metric weight K1=1, K2=0, K3=1, K4=0, K5=0
Topology : 0 (base)
Active Timer: 3 min
Distance: internal 90 external 170
Maximum path: 4
Maximum hopcount 100
Hello Time: 5 sec
Hold Time: 15 sec
```
在上面的输出中,可以看到 `Hello Time` 字段显示的是 5 秒。
华三路由器eigrp配置
华三路由器的 EIGRP 配置步骤如下:
1. 进入路由器的全局配置模式:configure terminal
2. 启用 EIGRP 协议:router eigrp [AS号]
3. 配置 EIGRP 路由器ID:eigrp router-id [路由器ID]
4. 配置 EIGRP 网络:network [网络地址]
5. 退出 EIGRP 配置模式:exit
6. 保存配置:write
例如,如果要启用 EIGRP 协议,AS号为100,路由器ID为1.1.1.1,网络地址为192.168.1.0/24,则配置命令如下:
configure terminal
router eigrp 100
eigrp router-id 1.1.1.1
network 192.168.1.0
exit
write