基于hal库 gpio设置代码
时间: 2024-02-18 08:59:56 浏览: 25
好的,以下是基于HAL库的GPIO设置代码示例:
```c
#include "stm32f1xx_hal.h"
/* 定义GPIO口 */
#define LED_PIN GPIO_PIN_13
#define LED_PORT GPIOC
int main(void)
{
/* 初始化HAL库 */
HAL_Init();
/* 使能GPIO时钟 */
__HAL_RCC_GPIOC_CLK_ENABLE();
/* 配置GPIO为推挽输出模式 */
GPIO_InitTypeDef GPIO_InitStruct = {0};
GPIO_InitStruct.Pin = LED_PIN;
GPIO_InitStruct.Mode = GPIO_MODE_OUTPUT_PP;
GPIO_InitStruct.Speed = GPIO_SPEED_FREQ_HIGH;
HAL_GPIO_Init(LED_PORT, &GPIO_InitStruct);
while (1)
{
/* 打开LED */
HAL_GPIO_WritePin(LED_PORT, LED_PIN, GPIO_PIN_SET);
/* 延时 */
HAL_Delay(500);
/* 关闭LED */
HAL_GPIO_WritePin(LED_PORT, LED_PIN, GPIO_PIN_RESET);
/* 延时 */
HAL_Delay(500);
}
}
```
以上代码中使用了HAL库的GPIO初始化函数 `HAL_GPIO_Init()`,来配置GPIO口的相关参数。同时使用了 `HAL_GPIO_WritePin()` 函数来控制GPIO口的输出状态,实现了LED的闪烁效果。
注:以上代码为基于STM32F1系列MCU的示例代码。如果您使用的是其他型号的MCU,请根据实际情况修改代码。