stm32f103c6t6实现串口通信代码
时间: 2023-08-31 11:13:00 浏览: 93
下面是一个简单的示例代码,使用USART1实现串口通信,波特率为9600:
```c
#include "stm32f10x.h"
#include <stdio.h>
void USART1_Init(void)
{
RCC_APB2PeriphClockCmd(RCC_APB2Periph_USART1 | RCC_APB2Periph_GPIOA, ENABLE);
GPIO_InitTypeDef GPIO_InitStructure;
USART_InitTypeDef USART_InitStructure;
// USART1_TX -> PA9, USART1_RX -> PA10
GPIO_InitStructure.GPIO_Pin = GPIO_Pin_9;
GPIO_InitStructure.GPIO_Speed = GPIO_Speed_50MHz;
GPIO_InitStructure.GPIO_Mode = GPIO_Mode_AF_PP;
GPIO_Init(GPIOA, &GPIO_InitStructure);
GPIO_InitStructure.GPIO_Pin = GPIO_Pin_10;
GPIO_InitStructure.GPIO_Mode = GPIO_Mode_IN_FLOATING;
GPIO_Init(GPIOA, &GPIO_InitStructure);
USART_InitStructure.USART_BaudRate = 9600;
USART_InitStructure.USART_WordLength = USART_WordLength_8b;
USART_InitStructure.USART_StopBits = USART_StopBits_1;
USART_InitStructure.USART_Parity = USART_Parity_No;
USART_InitStructure.USART_HardwareFlowControl = USART_HardwareFlowControl_None;
USART_InitStructure.USART_Mode = USART_Mode_Rx | USART_Mode_Tx;
USART_Init(USART1, &USART_InitStructure);
USART_Cmd(USART1, ENABLE);
}
int USART1_SendChar(int ch)
{
while (USART_GetFlagStatus(USART1, USART_FLAG_TXE) == RESET);
USART_SendData(USART1, (uint8_t)ch);
return ch;
}
int USART1_GetChar(void)
{
while (USART_GetFlagStatus(USART1, USART_FLAG_RXNE) == RESET);
return (int)USART_ReceiveData(USART1);
}
// 重定向printf到USART1
int fputc(int ch, FILE *f)
{
return USART1_SendChar(ch);
}
int main()
{
USART1_Init();
while (1) {
int ch = USART1_GetChar();
printf("Received: %c\n", ch);
}
}
```
在main()函数中,我们使用一个死循环来不断接收串口数据,并用printf()函数将接收到的数据输出到终端上。
需要注意的是,在使用printf()函数输出数据之前,我们需要将stdout重定向到USART1,这可以通过以下代码实现:
```c
int fputc(int ch, FILE *f)
{
return USART1_SendChar(ch);
}
```
这样,我们就可以在程序中使用printf()函数输出数据到USART1了。