arduino tcp客户端
时间: 2023-08-04 07:03:29 浏览: 45
好的,关于 Arduino TCP 客户端,以下是一个简单的参考代码:
```C++
#include <SPI.h>
#include <Ethernet.h>
// 定义 MAC 地址和 IP 地址
byte mac[] = {0xDE, 0xAD, 0xBE, 0xEF, 0xFE, 0xED};
IPAddress serverIP(192, 168, 1, 100);
// 创建 EthernetClient 对象
EthernetClient client;
void setup() {
Serial.begin(9600);
while (!Serial) {
; // 等待串口连接
}
// 启动以太网连接
if (Ethernet.begin(mac) == 0) {
Serial.println("Failed to configure Ethernet using DHCP");
// 尝试使用静态 IP 地址
Ethernet.begin(mac, IPAddress(192, 168, 1, 177));
}
// 连接到服务器
if (client.connect(serverIP, 80)) {
Serial.println("Connected to server");
// 发送数据
client.println("GET / HTTP/1.1");
client.println("Host: 192.168.1.100");
client.println("Connection: close");
client.println();
} else {
Serial.println("Connection failed");
}
}
void loop() {
// 等待服务器返回数据
while (client.connected()) {
if (client.available()) {
char c = client.read();
Serial.print(c);
}
}
// 断开连接
client.stop();
Serial.println("Disconnected from server");
// 延迟 5 秒后重新连接
delay(5000);
if (client.connect(serverIP, 80)) {
Serial.println("Connected to server");
// 发送数据
client.println("GET / HTTP/1.1");
client.println("Host: 192.168.1.100");
client.println("Connection: close");
client.println();
} else {
Serial.println("Connection failed");
}
}
```
在这个例子中,我们使用以太网库(Ethernet)来连接到网络,并使用 EthernetClient 对象来建立 TCP 连接。在 setup() 函数中,我们启动以太网连接并尝试连接到服务器。如果连接成功,我们发送一个 HTTP GET 请求并等待服务器返回数据。在 loop() 函数中,我们等待服务器返回所有数据后,关闭连接并重新连接到服务器。这里我们假设服务器的 IP 地址为 192.168.1.100,端口为 80。
请注意,这只是一个简单的参考代码,您可能需要根据您的具体需求进行修改。