ensp的stp根桥配置命令
时间: 2023-12-08 11:05:59 浏览: 255
为了配置ensp交换机为stp根桥,可以使用以下命令:
```
stp root primary
```
这个命令将会将ensp交换机的桥优先级设置为0,从而使其成为stp根桥。需要注意的是,这个命令应该在全局配置模式下使用。如果需要将其他交换机设置为次级桥,可以使用以下命令:
```
stp root secondary
```
这个命令将会将交换机的桥优先级设置为较高的值,从而使其成为次级桥。需要注意的是,这个命令也应该在全局配置模式下使用。
相关问题
ensp 中的stp交换机配置命令
ensp中的stp交换机配置命令包括:
1. 在接口视图下使用stp enable命令开启交换机STP功能。[interface interface-type interface-number] stp enable
2. 在接口视图下使用stp edged-port enable命令开启交换机STP的边缘端口。[interface interface-type interface-number] stp edged-port enable
3. 在全局模式下使用stp region-configuration命令配置STP的区域参数。stp region-configuration
4. 在接口视图下使用stp cost命令配置接口的路径成本。[interface interface-type interface-number] stp cost cost-value
5. 在接口视图下使用stp priority命令配置接口的桥优先级。[interface interface-type interface-number] stp priority priority-value
6. 在全局模式下使用stp root primary命令将当前交换机的桥优先级设置为最低,以确保其成为STP的根桥。stp root primary
ensp中,stp基础配置命令
在ENSP中,STP(Spanning Tree Protocol)的基础配置命令如下:
1. 开启STP协议:
```
stp enable
```
2. 配置STP的优先级(默认值为32768),可以通过设置优先级来控制STP的根桥:
```
stp priority priority-value
```
3. 配置STP的端口优先级(默认值为128),可以通过设置端口优先级来控制端口在STP中的状态:
```
interface interface-type interface-number
stp port priority priority-value
```
4. 配置STP的端口类型,包括边缘端口、非边缘端口和根端口:
```
interface interface-type interface-number
stp edged-port enable
```
```
interface interface-type interface-number
stp port type edge
```
```
interface interface-type interface-number
stp port type normal
```
5. 配置STP的端口状态,包括使能和禁用:
```
interface interface-type interface-number
stp enable
```
```
interface interface-type interface-number
stp disable
```
6. 查看STP的状态:
```
display stp
```
以上是ENSP中STP的基础配置命令,可以根据实际需要进行设置和调整。