IEEE-TIE/TTE 期刊论文格式与模板指南

word版本

需积分: 5 61 浏览量更新于2024-08-03 收藏 206KB DOCX 举报

身份认证购VIP最低享 7 折!

30元优惠券

"IEEE-TIE/TTE 期刊的论文格式要求和模板(word版本)" 撰写IEEE Transactions on Industrial Electronics (TIE) 或 Transactions on Transportation Electrification (TTE) 期刊的论文时，作者需要遵循特定的格式标准。这篇文档是针对使用Microsoft Word的作者准备的模板，同时也提供了详细的指示。以下是一些关键的格式要求和建议： 1. **标题**：标题应使用大写和小写字母，而不是全大写。避免在标题中插入复杂的带有下标的形式，简短的公式（如“Nd-Fe-B”）是可以接受的。请不要在标题中注明“Invited”。 2. **作者信息**：作者的全名是首选，但不是强制性的。作者的首字母之间应有空格。如果愿意，可以提供ORCID（Open Researcher and Contributor ID）。 3. **摘要**：摘要必须是一段单独的文字，用于简洁明了地概述研究的主要内容。为了在IEEE Xplore以及Compendex、INSPEC、Medline、ProQuest和Web of Science等索引服务中有效地展示，摘要需要独立且准确，能够自我包含。 4. **正文**：在文章的主体部分，所有变量应以斜体轻字体表示，而数字和单位则保持加粗。确保文章的结构清晰，包括引言、方法、结果和讨论等部分，并遵循期刊的特定引用样式。 5. **公式和符号**：复杂的数学公式应该使用适当的排版，确保可读性。使用方程式编辑器来创建和格式化数学表达式。 6. **图表和图像**：所有图表和图像都应有清晰的标题和详细说明，且在文中恰当的位置引用。图和表应有编号，并在正文中提及，例如：“见图1”或“如表2所示”。 7. **参考文献**：参考文献应按照期刊指定的引用样式列出，通常是IEEE Transactions引用样式，要求完整、准确，并遵循特定的排序规则。 8. **页眉和页脚**：通常，页眉应包含论文标题的缩写，页脚可能包含页码。具体要求可能会因期刊而异。 9. **审稿过程**：提交论文后，作者将参与同行评审过程，根据审稿人的反馈进行必要的修改。审稿过程是提升论文质量和学术严谨性的关键步骤。 10. **最终提交**：在满足所有格式要求并完成所有修订后，将最终电子版文章提交至IEEE的在线提交系统。确保文件格式符合期刊的要求，通常是PDF格式。遵循这些指导原则，将有助于确保您的论文符合IEEE TIE和TTE期刊的出版标准，从而提高被接受和发表的可能性。

资源详情

资源推荐

> REPLACE THIS LINE WITH YOUR MANUSCRIPT ID NUMBER (DOUBLE-CLICK HERE TO EDIT) <

Preparation of Articles for IEEE TRANSACTIONS and

JOURNALS (2022)

First A. Author, Fellow, IEEE, Second B. Author, and Third C. Author Jr., Member, IEEE

�

Abstract—This document provides a guide for preparing

articles for IEEE Transactions, Journals, and Letters. Use this

document as a template if you are using Microsoft Word.

Otherwise, use this as an instruction set. The electronic file of

your article will be formatted further at IEEE. Titles should be

written in uppercase and lowercase letters, not all uppercase.

Avoid writing long formulas with subscripts in the title; short

formulas that identify the elements are fine (e.g., "Nd–Fe–B").

Do not write “(Invited)” in the title. Full names of authors are

preferred in the author field but are not required. Put a space

between authors’ initials. ORCIDs can be provided here as well.

In the title, all variables should appear lightface italic; numbers

and units will remain bold. Abstracts must be a single paragraph.

In order for an Abstract to be effective when displayed in IEEE

Xplore as well as through indexing services such as Compendex,

INSPEC, Medline, ProQuest, and Web of Science, it must be an

accurate, stand-alone reflection of the contents of the article.

They shall not contain displayed mathematical equations,

numbered reference citations, nor footnotes. They should include

three or four different keywords or phrases, as this will help

readers to find it. It is important to avoid over-repetition of such

phrases as this can result in a page being rejected by search

engines. Ensure that your abstract reads well and is

grammatically correct.

Index Terms—Enter keywords or phrases in alphabetical order,

separated by commas. Using the IEEE Thesaurus can help you

find the best standardized keywords to fit your article. Use the

thesaurus access request form for free access to the IEEE

Thesaurus https://www.ieee.org/publications/services/thesaurus

.html.

This paragraph of the first footnote will contain the date on which you

submitted your paper for review, which is populated by IEEE. It is IEEE style

to display support information, including sponsor and financial support

acknowledgment, here and not in an acknowledgment section at the end of the

article. For example, “This work was supported in part by the U.S.

Department of Commerce under Grant 123456.” The name of the

corresponding author appears after the financial information, e.g.

(Corresponding author: Second B. Author). Here you may also indicate if

authors contributed equally or if there are co-first authors.

The next few paragraphs should contain the authors’ current affiliations,

including current address and e-mail. For example, First A. Author is with the

National Institute of Standards and Technology, Boulder, CO 80305 USA (e-

mail: author@ boulder.nist.gov).

Second B. Author Jr. was with Rice University, Houston, TX 77005 USA.

He is now with the Department of Physics, Colorado State University, Fort

Collins, CO 80523 USA (e-mail: author@lamar.colostate.edu).

Third C. Author is with the Electrical Engineering Department, University

of Colorado, Boulder, CO 80309 USA, on leave from the National Research

Institute for Metals, Tsukuba 305-0047, Japan (e-mail: author@nrim.go.jp).

Mentions of supplemental materials and animal/human rights statements

can be included here.

Color versions of one or more of the figures in this article are available

online at http://ieeexplore.ieee.org

I. INTRODUCTION

HIS document is a template for Microsoft Word. If you would

prefer to use LaTeX, download IEEE’s LaTeX style and

sample files from https://template-

selector.ieee.org/secure/templateSelector/publicationType.

You can also use the Overleaf editor at

https://www.overleaf.com/blog/278-how-to-use-overleaf-with-

ieee-collabratec-your-quick-guide-to-getting-

started#.Vp6tpPkrKM9.

This template is a guide to formatting; your proof and final

published version may vary in layout and length to conform to

IEEE policy and style. Page count is an estimate; the length of

your submitted article in the template may not be the same as

when the formal proof is created by IEEE

The IEEE Editorial Style Manual for Authors is available at

https://journals.ieeeauthorcenter.ieee.org/create-your-ieee-

journal-article/create-the-text-of-your-article/ieee-editorial-

style-manual/. This contains a formal set of editorial guidelines

for IEEE Transactions, Journals, and Letters, including:

● punctuation;

● capitalization;

● abbreviations;

● section headings;

● numbers, equations;

● footnotes;

● biographies;

● some common mistakes;

● units of measurement.

Communicate your work clearly. If you are not fully

proficient in English, consider using an English language

editing service before submitting your article. An expert

editing service can help you refine the use of English in your

article, so you can communicate your work more effectively.

The use of an editing service is paid for by the author. It

does not guarantee acceptance in an IEEE publication. For

more information, visit the IEEE Author Center at

https://journals.ieeeauthorcenter.ieee.org/create-your-ieee-

journal-article/create-the-text-of-your-article/structure-your-

article/#editing-service.

II. GUIDELINES FOR MANUSCRIPT PREPARATION

When you open the template, select “Page Layout” from the

“View” menu in the menu bar (View | Page Layout), (these

instructions assume Microsoft Word. Some versions may have

下载后可阅读完整内容，剩余6页未读，立即下载

keyan_doge

粉丝: 0
资源: 2

IEEE-TIE/TTE 期刊论文格式与模板指南

最新资源