没有合适的资源?快使用搜索试试~ 我知道了~
首页Zynq-7000 ZC706 Getting Started Guide
资源详情
资源评论
资源推荐
0402927-02
Zynq-7000
All Programmable SoC
ZC706 Evaluation Kit
(ISE Design Suite 14.5)
Getting Started Guide
UG961 (v3.0) May 13, 2013
2 www.xilinx.com ZC706 Getting Started Guide
UG961 (v3.0) May 13, 2013
Notice of Disclaimer
The information disclosed to you hereunder (the “Materials”) is provided solely for the selection and use of Xilinx products. To the maximum
extent permitted by applicable law: (1) Materials are made available “AS IS” and with all faults, Xilinx hereby DISCLAIMS ALL WARRANTIES
AND CONDITIONS, EXPRESS, IMPLIED, OR STATUTORY, INCLUDING BUT NOT LIMITED TO WARRANTIES OF MERCHANTABILITY,
NON-INFRINGEMENT, OR FITNESS FOR ANY PARTICULAR PURPOSE; and (2) Xilinx shall not be liable (whether in contract or tort, including
negligence, or under any other theory of liability) for any loss or damage of any kind or nature related to, arising under, or in connection with,
the Materials (including your use of the Materials), including for any direct, indirect, special, incidental, or consequential loss or damage
(including loss of data, profits, goodwill, or any type of loss or damage suffered as a result of any action brought by a third party) even if such
damage or loss was reasonably foreseeable or Xilinx had been advised of the possibility of the same. Xilinx assumes no obligation to correct
any errors contained in the Materials or to notify you of updates to the Materials or to product specifications. You may not reproduce,
modify, distribute, or publicly display the Materials without prior written consent. Certain products are subject to the terms and conditions
of the Limited Warranties which can be viewed at http://www.xilinx.com/warranty.htm
; IP cores may be subject to warranty and support
terms contained in a license issued to you by Xilinx. Xilinx products are not designed or intended to be fail-safe or for use in any application
requiring fail-safe performance; you assume sole risk and liability for use of Xilinx products in Critical Applications:
http://www.xilinx.com/warranty.htm#critapps
.
Automotive Applications Disclaimer
XILINX PRODUCTS ARE NOT DESIGNED OR INTENDED TO BE FAIL-SAFE, OR FOR USE IN ANY APPLICATION REQUIRING FAIL-SAFE
PERFORMANCE, SUCH AS APPLICATIONS RELATED TO: (I) THE DEPLOYMENT OF AIRBAGS, (II) CONTROL OF A VEHICLE, UNLESS THERE IS A
FAIL-SAFE OR REDUNDANCY FEATURE (WHICH DOES NOT INCLUDE USE OF SOFTWARE IN THE XILINX DEVICE TO IMPLEMENT THE
REDUNDANCY) AND A WARNING SIGNAL UPON FAILURE TO THE OPERATOR, OR (III) USES THAT COULD LEAD TO DEATH OR PERSONAL
INJURY. CUSTOMER ASSUMES THE SOLE RISK AND LIABILITY OF ANY USE OF XILINX PRODUCTS IN SUCH APPLICATIONS.
© Copyright 2012–2013 Xilinx, Inc. Xilinx, the Xilinx logo, Artix, ISE, Kintex, Spartan, Virtex, Vivado, Zynq, and other designated brands
included herein are trademarks of Xilinx in the United States and other countries. AMBA, AMBA Designer, ARM, ARM1176JZ-S, CoreSight,
Cortex, and PrimeCell are trademarks of ARM in the EU and other countries. PCI, PCIe, and PCI Express are trademarks of PCI-SIG and used
under license. HDMI, HDMI logo, and High-Definition Multimedia Interface are trademarks of HDMI Licensing LLC. All other trademarks are
the property of their respective owners.
ZC706 Getting Started Guide www.xilinx.com 3
UG961 (v3.0) May 13, 2013
Revision History
The following table shows the revision history for this document.
Date Version Revision
11/19/12 1.0
Initial Xilinx release.
01/23/13 2.0
Updated for ISE® Design Suite 14.4.
Chapter 1: Introduction, page 7 removed “Note: Users of the new Intel® Ivy Bridge . .
.” Figure 1-1, the kit photograph, was replaced. In section ZC706 Evaluation Kit
Contents, page 8, added this bullet on page 7: “ATX adapter cable, Xilinx part number
2600304.” The Key Features section was removed, because features are listed in ZC706
Evaluation Board for the Zynq-7000 XC7Z045 All Programmable SoC User Guide
(UG954
).
Chapter 2: In Figure 2-2, the switch 4 position changed. In Hardware Test Setup,
page 21, the ZC706 Evaluation Kit Contents section was removed.
Chapter 3: A note was added on page 22 that though the procedures mention version
14.3, the user should find the latest version of tools online. In Recommended
Motherboards, page 22, the boards are now Sandy Bridge and Ivy Bridge. Removed
“Tip: The Intel X58 chipsets tend to show higher performance” from page 24. In
Figure 3-3, J17 changed to J21. The Figure 3-4 figure title changed to “SW11 SD Boot
Mode Settings” and the switch 3 position changed. Added new Figure 3-6 and step 10
above it. The ELF file in step 9, page 25 changed to zynq_pcie_qt.elf,
zynq_pcie_cmd.elf. Installing ZC706 Board in the Host Computer Chassis,
page 26 now ends with step 8, page 26. Connecting the HDMI cable was added in
step 7, page 26. In Host Computer Bootup, page 27, replaced last sentences in step 1.
Split step 1 into two steps to show two different actions. Replaced Figure 3-9 and
added Table 3-1 to clarify LED settings. LED L and LED R were reversed in step 2 of Host
Computer Bootup. Added to step 3, page 29. Replaced Figure 3-15 and Figure 3-16.
05/13/2013 3.0
Replaced all references to zynq_pcie_trd_14_3.zip with
zc706-pcie-trd-rdf0287.zip throughout document. Identified location of the
PMBus connector in Figure 2-1. Added Note describing SW4 DIP switch setting in
ZC706 Evaluation Board Setup, page 10. Removed note on page 22 mentioning ISE
Design Suite version 14.3. Updated Figure 3-11, Figure 3-12, and Figure 3-14 screen
captures. Revised step 8, page 32. Updated Figure 3-17. Updated links to Xilinx
documents and updated link to Zc702 Base TRD (wiki page)
http://www.wiki.xilinx.com/Zc702+Base+TRD
in Appendix A, Additional Resources.
ZC706 Getting Started Guide www.xilinx.com 5
UG961 (v3.0) May 13, 2013
Table of Contents
Revision History . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Chapter 1: Introduction
ZC706 Evaluation Kit Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Chapter 2: ZC706 Evaluation Kit Built-In Self-Test
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Built-In Self-Test Setup Requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
Hardware Test Board Setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
Run the BIST Application . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
Chapter 3: Getting Started with the ZC706 PCIe Targeted Reference Design
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17
Key Components . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19
Data Flow . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20
Hardware Test Setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21
Programming the ZC706 Board . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22
TRD Demonstration Setup. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 26
Appendix A: Additional Resources
Xilinx Resources . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 37
Solution Centers. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 37
Further Resources . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 37
References . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 39
Appendix B: Warranty
剩余41页未读,继续阅读
白马青衫等风来
- 粉丝: 13
- 资源: 8
上传资源 快速赚钱
- 我的内容管理 收起
- 我的资源 快来上传第一个资源
- 我的收益 登录查看自己的收益
- 我的积分 登录查看自己的积分
- 我的C币 登录后查看C币余额
- 我的收藏
- 我的下载
- 下载帮助
会员权益专享
最新资源
- c++校园超市商品信息管理系统课程设计说明书(含源代码) (2).pdf
- 建筑供配电系统相关课件.pptx
- 企业管理规章制度及管理模式.doc
- vb打开摄像头.doc
- 云计算-可信计算中认证协议改进方案.pdf
- [详细完整版]单片机编程4.ppt
- c语言常用算法.pdf
- c++经典程序代码大全.pdf
- 单片机数字时钟资料.doc
- 11项目管理前沿1.0.pptx
- 基于ssm的“魅力”繁峙宣传网站的设计与实现论文.doc
- 智慧交通综合解决方案.pptx
- 建筑防潮设计-PowerPointPresentati.pptx
- SPC统计过程控制程序.pptx
- SPC统计方法基础知识.pptx
- MW全能培训汽轮机调节保安系统PPT教学课件.pptx
资源上传下载、课程学习等过程中有任何疑问或建议,欢迎提出宝贵意见哦~我们会及时处理!
点击此处反馈
安全验证
文档复制为VIP权益,开通VIP直接复制
信息提交成功
评论0