没有合适的资源?快使用搜索试试~ 我知道了~
首页ISO20860-1-2008第1版中文.pdf
ISO20860-1-2008第1版中文.pdf
需积分: 50 1.3k 浏览量
更新于2023-05-30
评论
收藏 729KB PDF 举报
ISO 20860-1:2008规定了用于道路车辆射频应用的50欧姆阻抗系统接口的公、母连接器,并确保与道路车辆之间的通信。它规定了互换性所需的尺寸和电气要求以及特性。该连接系统可应用于道路车辆的所有相关设备和电缆连接。
资源详情
资源评论
资源推荐

国际
ISO
标准
20860-1
第一版
2008-10-15
道路车辆—50Ω阻抗射频连接系统接口—
第1部分:
尺寸和电气要求
Véhicules routiers — Interface de système de connexion de
fréquence radio de 50
Ω
—
Partie 1: Dimensions et exigences électriques
Reference number
ISO 20860-1:2008(E)
© ISO 2008

ISO 20860-1:2008(E)
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but
shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In
downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat
accepts no liability in this area.
Adobe is a trademark of Adobe Systems Incorporated.
Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation
parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In
the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below.
COPYRIGHT PROTECTED DOCUMENT
© ISO 2008
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or
ISO's member body in the country of the requester.
ISO copyright office
Case postale 56 CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland
ii
© ISO 2008 – All rights reserved

目录
ISO 20860-1:2008(E)
Page
前言 ....................................................................................................................................................................................
iv
1 范围 .........................................................................................................................................................................
1
2 标准引用 .................................................................................................................................................................
1
3
条件和定义 ........................................................................................................................................................... 1
4
尺寸和编码 ........................................................................................................................................................... 2
4.1
总概 ........................................................................................................................................................................ 2
4.2
公头连接器 ........................................................................................................................................................... 2
4.3
母座连接器 ........................................................................................................................................................... 2
4.4
编码带 ................................................................................................................................................................... 2
4.5
连接系统的机械和色码 ..................................................................................................................................... 2
4.6
多接口 ................................................................................................................................................................... 2
5
称号 ........................................................................................................................................................................ 9
6
特征值 ................................................................................................................................................................... 9
7
测试程序 ............................................................................................................................................................ 11
参考书目 .......................................................................................................................................................................... 12
© ISO 2008 – All rights reserved iii

ISO 20860-1:2008(E)
前言
ISO(国际标准化组织)是一个由国家标准机构(ISO 成员机构)组成的世界性联合会。编制国际标准的工作通常是通过 ISO
技术委员会进行的。对已设立技术委员会的主题感兴趣的每个成员机构都有权派代表参加该委员会。国际组织,政府和非政
府组织,与国际标准化组织联络,也参与这项工作。ISO 与国际电工委员会(IEC)在电工技术标准化的所有问题上密切合
作。
国际标准是根据 ISO/IEC 指令第 2 部分中给出的规则起草的。
技术委员会的主要任务是制定国际标准。各技术委员会通过的国际标准草案将分发给各成员机构表决。作为国际标准出版需
要至少 75%的投票成员机构的批准。
请注意,本文件的某些要素可能是专利权的主体。ISO 不负责识别任何或所有此类专利权。
频率、连接器系统接口
ISO 20860-1 由道路车辆技术委员会 ISO/TC 22 编制。
ISO 20860 由以下部分组成,在一般标题下为道路车辆-50Ω 阻抗无线电
第 1 部分:尺寸和电气要求
第 2 部分:试验程序
iv
© ISO 2008 – All rights reserved
剩余17页未读,继续阅读












zhuzhimiao
- 粉丝: 3
- 资源: 4
上传资源 快速赚钱
我的内容管理 收起
我的资源 快来上传第一个资源
我的收益
登录查看自己的收益我的积分 登录查看自己的积分
我的C币 登录后查看C币余额
我的收藏
我的下载
下载帮助

会员权益专享
最新资源
- ARM Cortex-A(armV7)编程手册V4.0.pdf
- ABB机器人保养总结解析.ppt
- 【超详细图解】菜鸡如何理解双向链表的python代码实现
- 常用网络命令的使用 ipconfig ping ARP FTP Netstat Route Tftp Tracert Telnet nslookup
- 基于单片机控制的DC-DC变换电路
- RS-232接口电路的ESD保护.pdf
- linux下用time(NULL)函数和localtime()获取当前时间的方法
- Openstack用户使用手册.docx
- KUKA KR 30 hA,KR 60 hA机器人产品手册.pdf
- Java programming with JNI
资源上传下载、课程学习等过程中有任何疑问或建议,欢迎提出宝贵意见哦~我们会及时处理!
点击此处反馈



安全验证
文档复制为VIP权益,开通VIP直接复制

评论0