请以思科模拟器为例给我完成配置过程
时间: 2023-10-11 22:20:33 浏览: 46
好的,以下是使用思科模拟器(Cisco Packet Tracer)进行配置的步骤:
1. 打开思科模拟器,并创建一个新的拓扑图。
2. 从设备列表中选择所需的设备,并将其拖放到拓扑图中。在本例中,需要添加三个路由器和三个PC。
3. 右键单击每个设备,选择“配置”选项,打开设备的CLI命令行界面。
4. 在School Router中,输入以下命令来配置Fa0/0接口的IP地址和网关:
```
enable
configure terminal
interface Fa0/0
ip address 10.0.0.1 255.255.255.0
no shutdown
exit
ip default-gateway 10.0.0.1
```
然后,配置Se0/0/0接口的IP地址和时钟频率:
```
interface Se0/0/0
ip address 10.1.0.1 255.255.255.0
no shutdown
clock rate 64000
exit
```
5. 在Internet Router中,输入以下命令来配置Fa0/0、Se0/0/0和Se0/0/1接口的IP地址和网关:
```
enable
configure terminal
interface Fa0/0
ip address 10.2.0.1 255.255.255.0
no shutdown
exit
interface Se0/0/0
ip address 10.1.0.2 255.255.255.0
no shutdown
clock rate 64000
exit
interface Se0/0/1
ip address 10.3.0.1 255.255.255.0
no shutdown
clock rate 64000
exit
ip default-gateway 10.2.0.1
```
6. 在Example Router中,输入以下命令来配置Fa0/0和Se0/0/0接口的IP地址:
```
enable
configure terminal
interface Fa0/0
ip address 10.4.0.1 255.255.255.0
no shutdown
exit
interface Se0/0/0
ip address 10.3.0.2 255.255.255.0
no shutdown
clock rate 64000
exit
```
7. 在PC1、Local DNS Server、Root DNS Server、authority.example.edu和server.example.edu中,输入以下命令来配置IP地址和网关:
```
ip address 10.0.0.2 255.255.255.0 10.0.0.1
```
```
ip address 10.0.0.3 255.255.255.0 10.0.0.1
```
```
ip address 10.2.0.2 255.255.255.0 10.2.0.1
```
```
ip address 10.4.0.2 255.255.255.0 10.4.0.1
```
```
ip address 10.4.0.3 255.255.255.0 10.4.0.1
```
8. 确认各个设备的配置是否正确。
9. 保存并运行拓扑图,测试网络是否正常工作。
注意:以上命令仅供参考,具体配置可能会因设备型号、软件版本、网络拓扑等因素而异。在实际配置中,请务必仔细阅读设备文档并按照要求进行配置。