hc05蓝牙模块与stm32连接
时间: 2023-06-11 07:10:32 浏览: 74
连接 HC-05 蓝牙模块与 STM32 微控制器的方法如下:
1. 将 HC-05 模块的 VCC 引脚连接到 STM32 微控制器的 3.3V 引脚,将 GND 引脚连接到 STM32 微控制器的 GND 引脚。
2. 将 HC-05 模块的 TX 引脚连接到 STM32 微控制器的 RX 引脚,将 HC-05 模块的 RX 引脚连接到 STM32 微控制器的 TX 引脚。
3. 在 STM32 微控制器上编程,使用串口通信协议与 HC-05 模块进行通信。
以下是一个简单的示例程序,可以将 STM32 微控制器上的字符串发送到 HC-05 模块:
```c
#include "stm32f10x.h"
void USART1_Init(void)
{
GPIO_InitTypeDef GPIO_InitStructure;
USART_InitTypeDef USART_InitStructure;
/* Enable GPIO clock */
RCC_APB2PeriphClockCmd(RCC_APB2Periph_GPIOA, ENABLE);
/* Enable USART clock */
RCC_APB2PeriphClockCmd(RCC_APB2Periph_USART1, ENABLE);
/* Configure USART Tx as alternate function push-pull */
GPIO_InitStructure.GPIO_Pin = GPIO_Pin_9;
GPIO_InitStructure.GPIO_Mode = GPIO_Mode_AF_PP;
GPIO_InitStructure.GPIO_Speed = GPIO_Speed_50MHz;
GPIO_Init(GPIOA, &GPIO_InitStructure);
/* Configure USART Rx as input floating */
GPIO_InitStructure.GPIO_Pin = GPIO_Pin_10;
GPIO_InitStructure.GPIO_Mode = GPIO_Mode_IN_FLOATING;
GPIO_Init(GPIOA, &GPIO_InitStructure);
/* USART configuration */
USART_InitStructure.USART_BaudRate = 9600;
USART_InitStructure.USART_WordLength = USART_WordLength_8b;
USART_InitStructure.USART_StopBits = USART_StopBits_1;
USART_InitStructure.USART_Parity = USART_Parity_No;
USART_InitStructure.USART_HardwareFlowControl = USART_HardwareFlowControl_None;
USART_InitStructure.USART_Mode = USART_Mode_Rx | USART_Mode_Tx;
USART_Init(USART1, &USART_InitStructure);
/* Enable USART */
USART_Cmd(USART1, ENABLE);
}
void USART1_SendString(char* s)
{
while (*s)
{
while (!(USART1->SR & USART_FLAG_TXE));
USART_SendData(USART1, *s++);
}
}
int main(void)
{
USART1_Init();
while (1)
{
USART1_SendString("Hello, World!\r\n");
}
}
```
在使用 HC-05 模块之前,需要在 HC-05 模块上进行一些设置,例如设置蓝牙名称、波特率等。具体操作可以参考 HC-05 模块的说明书。