画一个长整数处理的各个功能函数的程序流程图
时间: 2024-02-01 10:06:23 浏览: 27
好的,我会根据你的要求画一个长整数处理的各个功能函数的程序流程图。以下是程序流程图的示例:
```
+-------------------------------------------+
| Main Function |
+-------------------------------------------+
| |
| 1. Read input numbers |
| 2. Choose operation |
| 3. Call corresponding function |
| |
+-------------------------------------------+
+-------------------------------------------+
| Addition Function |
+-------------------------------------------+
| |
| 1. Initialize carry bit to zero |
| 2. Loop through each digit of both numbers |
| 3. Add the corresponding digits |
| 4. Add the carry bit |
| 5. Check if the result is greater than 10 |
| 6. Set carry bit if result is greater than 10 |
| 7. Store result in output variable |
| 8. Return output variable |
| |
+-------------------------------------------+
+-------------------------------------------+
| Subtraction Function |
+-------------------------------------------+
| |
| 1. Initialize borrow bit to zero |
| 2. Loop through each digit of both numbers |
| 3. Subtract the corresponding digits |
| 4. Subtract the borrow bit |
| 5. Check if the result is negative |
| 6. Set borrow bit if result is negative |
| 7. Store result in output variable |
| 8. Return output variable |
| |
+-------------------------------------------+
+-------------------------------------------+
| Multiplication Function |
+-------------------------------------------+
| |
| 1. Initialize result to zero |
| 2. Loop through each digit of second number|
| 3. Multiply the first number with the digit|
| 4. Add the result to the previous result |
| 5. Store result in output variable |
| 6. Return output variable |
| |
+-------------------------------------------+
+-------------------------------------------+
| Division Function |
+-------------------------------------------+
| |
| 1. Initialize quotient and remainder to zero|
| 2. Loop through each digit of dividend |
| 3. Shift remainder left by one position |
| 4. Add the next digit to remainder |
| 5. If remainder is greater than divisor, |
| subtract divisor from remainder |
| and set corresponding bit in quotient. |
| 6. Store quotient and remainder in output |
| variables |
| 7. Return output variables |
| |
+-------------------------------------------+
```
请注意,这只是一个示例程序流程图,实际的程序流程图可能会根据实际需求而有所不同。