RT-Thread 中使用串口需要如何配置
时间: 2024-03-10 20:44:46 浏览: 15
在 RT-Thread 中使用串口,需要进行以下配置:
1. 配置串口驱动:在 RT-Thread 的 BSP 配置文件中,找到串口驱动并使能。例如,在 STM32F4xx 的 BSP 配置文件中,可以找到以下代码:
```
#define BSP_USING_UART1
#define BSP_USING_UART2
#define BSP_USING_UART3
#define BSP_USING_UART4
#define BSP_USING_UART5
#define BSP_USING_USART1
#define BSP_USING_USART2
#define BSP_USING_USART3
#define BSP_USING_UART8
```
将需要使用的串口宏定义为 1,即表示启用该串口。
2. 配置串口参数:在应用程序中,需要配置串口的波特率、数据位、停止位和校验位等参数。可以使用 RT-Thread 提供的串口控制接口 `rt_device_control()` 进行配置。例如,下面的代码配置串口 1 的波特率为 115200,数据位为 8,停止位为 1,无校验位:
```
#include <rtthread.h>
#include <rtdevice.h>
int main(void)
{
rt_device_t serial;
struct serial_configure config = RT_SERIAL_CONFIG_DEFAULT;
serial = rt_device_find("uart1");
rt_device_open(serial, RT_DEVICE_FLAG_INT_RX);
config.baud_rate = BAUD_RATE_115200;
config.data_bits = DATA_BITS_8;
config.stop_bits = STOP_BITS_1;
config.parity = PARITY_NONE;
rt_device_control(serial, RT_DEVICE_CTRL_CONFIG, &config);
return 0;
}
```
在上述代码中,首先使用 `rt_device_find()` 函数查找串口设备,然后打开串口设备并使能接收中断。接着,使用 `rt_device_control()` 函数配置串口参数。
3. 使用串口:使用 RT-Thread 提供的 `rt_device_read()` 和 `rt_device_write()` 函数进行串口数据的读写操作。例如,下面的代码从串口 1 中读取数据并打印出来:
```
#include <rtthread.h>
#include <rtdevice.h>
int main(void)
{
rt_device_t serial;
char buf[20];
int len;
serial = rt_device_find("uart1");
rt_device_open(serial, RT_DEVICE_FLAG_INT_RX);
while (1)
{
len = rt_device_read(serial, 0, buf, sizeof(buf));
if (len > 0)
{
rt_kprintf("Received: %s\n", buf);
}
}
return 0;
}
```
在上述代码中,使用 `rt_device_read()` 函数从串口中读取数据,并使用 `rt_kprintf()` 函数打印出来。
以上就是在 RT-Thread 中使用串口的配置方法。