基于STM32标准库接PD7引脚HS0038B红外遥控控制PB1 LED的程序
时间: 2024-05-16 17:18:30 浏览: 9
以下是基于STM32标准库接PD7引脚HS0038B红外遥控控制PB1 LED的示例程序:
```c
#include "stm32f10x.h"
#define IR_PIN GPIO_Pin_7
#define IR_PORT GPIOD
#define IR_RCC RCC_APB2Periph_GPIOD
#define LED_PIN GPIO_Pin_1
#define LED_PORT GPIOB
#define LED_RCC RCC_APB2Periph_GPIOB
void ir_init(void);
void led_init(void);
int main(void)
{
ir_init();
led_init();
while(1)
{
if(GPIO_ReadInputDataBit(IR_PORT, IR_PIN) == RESET)
{
GPIO_SetBits(LED_PORT, LED_PIN);
delay_ms(500);
GPIO_ResetBits(LED_PORT, LED_PIN);
delay_ms(500);
}
}
}
void ir_init(void)
{
GPIO_InitTypeDef GPIO_InitStructure;
RCC_APB2PeriphClockCmd(IR_RCC, ENABLE);
GPIO_InitStructure.GPIO_Pin = IR_PIN;
GPIO_InitStructure.GPIO_Mode = GPIO_Mode_IN_FLOATING;
GPIO_Init(IR_PORT, &GPIO_InitStructure);
}
void led_init(void)
{
GPIO_InitTypeDef GPIO_InitStructure;
RCC_APB2PeriphClockCmd(LED_RCC, ENABLE);
GPIO_InitStructure.GPIO_Pin = LED_PIN;
GPIO_InitStructure.GPIO_Mode = GPIO_Mode_Out_PP;
GPIO_InitStructure.GPIO_Speed = GPIO_Speed_50MHz;
GPIO_Init(LED_PORT, &GPIO_InitStructure);
}
void delay_ms(uint16_t ms)
{
while(ms--)
{
uint16_t i = 1000;
while(i--);
}
}
```
在该程序中,我们首先定义了引脚和端口的宏定义,然后分别编写了红外接收器和LED初始化函数。在主函数中,我们不断读取PD7引脚的状态,如果检测到有红外信号输入,则控制PB1引脚的LED灯闪烁。最后我们还编写了一个简单的延时函数,用于控制LED灯的闪烁频率。
需要注意的是,以上代码仅为示例代码,实际应用中需要根据具体的硬件电路和红外遥控器的协议进行调整和修改。