其蓝牙模块代码
时间: 2023-08-06 07:02:59 浏览: 109
蓝牙模块的代码通常需要根据具体的模块型号和使用场景进行编写,以下是一个基于Arduino平台的HM-10蓝牙模块的示例代码,可以实现温湿度数据的采集和蓝牙传输:
```
#include <SoftwareSerial.h>
//定义软串口接收和发送引脚
SoftwareSerial bluetooth(2, 3);
//定义温湿度传感器引脚
#define DHT11_PIN 4
void setup() {
Serial.begin(9600);
bluetooth.begin(9600);
}
void loop() {
//读取温湿度传感器数据
int h = 0, t = 0;
readDHT11(h, t);
//将温湿度数据转换为字符串
String data = String(h) + "," + String(t);
//将数据通过蓝牙发送出去
bluetooth.println(data);
}
void readDHT11(int& h, int& t) {
int chk = DHT11_CHECKSUM_ERROR;
byte dht11_dat[5] = {0, 0, 0, 0, 0};
pinMode(DHT11_PIN, OUTPUT);
digitalWrite(DHT11_PIN, LOW);
delay(18);
digitalWrite(DHT11_PIN, HIGH);
delayMicroseconds(40);
pinMode(DHT11_PIN, INPUT);
for(int i = 0; i < 85; i++) {
int idx = i / 8;
int bit = 7 - i % 8;
while(digitalRead(DHT11_PIN) == LOW);
unsigned long t = micros();
while(digitalRead(DHT11_PIN) == HIGH);
if(micros() - t > 40) dht11_dat[idx] |= (1 << bit);
}
h = dht11_dat[0];
t = dht11_dat[2];
chk = dht11_dat[4];
if(h + t == chk) {
Serial.print("Humidity = ");
Serial.print(h);
Serial.print("%, Temperature = ");
Serial.print(t);
Serial.println("C");
} else {
Serial.println("DHT11 checksum error");
}
}
```
这段代码通过读取DHT11温湿度传感器的数据,将温度和湿度数据转换成字符串格式,然后通过蓝牙模块发送出去。需要注意的是,代码中的蓝牙模块为HM-10,如果您使用的是其他型号的蓝牙模块,可能需要进行相应的修改。