stm32f103连接蓝牙模块代码
时间: 2023-08-22 14:04:37 浏览: 88
以下是一个示例代码,用于将STM32F103与蓝牙模块进行连接:
```c
#include "stm32f10x.h"
#include "stdio.h"
// 定义蓝牙模块的串口
#define UART_PORT GPIOA
#define UART_PIN_TX GPIO_Pin_9
#define UART_PIN_RX GPIO_Pin_10
void USART1_Init(void)
{
GPIO_InitTypeDef GPIO_InitStructure;
USART_InitTypeDef USART_InitStructure;
// 使能USART1与GPIOA的时钟
RCC_APB2PeriphClockCmd(RCC_APB2Periph_USART1 | RCC_APB2Periph_GPIOA, ENABLE);
// USART1的引脚配置
GPIO_InitStructure.GPIO_Pin = UART_PIN_TX;
GPIO_InitStructure.GPIO_Speed = GPIO_Speed_50MHz;
GPIO_InitStructure.GPIO_Mode = GPIO_Mode_AF_PP;
GPIO_Init(UART_PORT, &GPIO_InitStructure);
GPIO_InitStructure.GPIO_Pin = UART_PIN_RX;
GPIO_InitStructure.GPIO_Mode = GPIO_Mode_IN_FLOATING;
GPIO_Init(UART_PORT, &GPIO_InitStructure);
// USART1的配置
USART_InitStructure.USART_BaudRate = 9600;
USART_InitStructure.USART_WordLength = USART_WordLength_8b;
USART_InitStructure.USART_StopBits = USART_StopBits_1;
USART_InitStructure.USART_Parity = USART_Parity_No;
USART_InitStructure.USART_HardwareFlowControl = USART_HardwareFlowControl_None;
USART_InitStructure.USART_Mode = USART_Mode_Rx | USART_Mode_Tx;
USART_Init(USART1, &USART_InitStructure);
// 使能USART1
USART_Cmd(USART1, ENABLE);
}
void USART1_SendChar(uint8_t ch)
{
// 等待发送缓冲区为空
while (USART_GetFlagStatus(USART1, USART_FLAG_TXE) == RESET);
// 将数据发送到USART1
USART_SendData(USART1, (uint8_t)ch);
}
int main(void)
{
USART1_Init();
while (1)
{
// 接收蓝牙模块发送的数据
if (USART_GetFlagStatus(USART1, USART_FLAG_RXNE) == SET)
{
uint8_t data = USART_ReceiveData(USART1);
// 处理接收到的数据
// ...
}
// 发送数据到蓝牙模块
// USART1_SendChar(data);
}
}
```
上述代码使用USART1与STM32F103的GPIOA连接,其中PA9为USART1的TX引脚,PA10为USART1的RX引脚。你可以根据需要进行修改来适配你的硬件连接。