uart点亮led,用c语言来编写这个程序
时间: 2023-12-20 22:55:24 浏览: 27
以下是一个简单的C语言程序,使用UART串口通信来点亮LED灯:
```c
#include <stdio.h>
#include <stdlib.h>
#include <unistd.h>
#include <fcntl.h>
#include <termios.h>
#define LED_PIN 18 // GPIO 18,树莓派上的LED灯引脚号
int main()
{
int fd;
struct termios options;
// 打开串口设备文件
fd = open("/dev/serial0", O_RDWR | O_NOCTTY | O_NDELAY);
if (fd == -1) {
perror("open");
exit(1);
}
// 配置串口参数
tcgetattr(fd, &options);
cfsetispeed(&options, B9600); // 设置波特率为9600
cfsetospeed(&options, B9600);
options.c_cflag |= (CLOCAL | CREAD);
options.c_cflag &= ~PARENB; // 无奇偶校验位
options.c_cflag &= ~CSTOPB; // 1个停止位
options.c_cflag &= ~CSIZE;
options.c_cflag |= CS8; // 8位数据位
options.c_lflag &= ~(ICANON | ECHO | ECHOE | ISIG);
options.c_oflag &= ~OPOST;
tcsetattr(fd, TCSANOW, &options);
// 等待接收到字符
char c;
while (1) {
read(fd, &c, 1);
if (c == '1') {
// 点亮LED
int fd_led = open("/sys/class/gpio/gpio18/value", O_WRONLY);
if (fd_led == -1) {
perror("open");
exit(1);
}
write(fd_led, "1", 1);
close(fd_led);
} else if (c == '0') {
// 熄灭LED
int fd_led = open("/sys/class/gpio/gpio18/value", O_WRONLY);
if (fd_led == -1) {
perror("open");
exit(1);
}
write(fd_led, "0", 1);
close(fd_led);
}
}
close(fd);
return 0;
}
```
这个程序使用了Linux系统上的串口设备文件`/dev/serial0`,并且通过配置`termios`结构体来设置串口参数。在程序中,我们不断地从串口设备文件中读取一个字符,当字符为`'1'`时点亮LED灯,当字符为`'0'`时熄灭LED灯。在树莓派上,我们可以通过修改GPIO的值来控制LED灯的状态,因此我们在程序中使用了`open()`和`write()`函数来修改GPIO值。需要注意的是,我们需要先将GPIO引脚设置为输出模式,才能够对其进行控制。