Ubuntu编写c语言串口通信并验证
时间: 2024-01-22 08:40:23 浏览: 33
步骤如下:
1. 安装串口调试工具:在终端输入命令 `sudo apt-get install minicom`,安装完成后输入 `sudo minicom -s` 进入配置界面。
2. 配置串口参数:在配置界面中选择 “Serial port setup”,设置串口号、波特率、数据位、校验位等参数。按下 “Save setup as dfl” 保存默认配置。
3. 打开串口调试工具:在终端输入命令 `sudo minicom`,打开串口调试工具。
4. 编写C语言程序:在终端输入命令 `sudo nano serial.c`,创建一个名为 serial.c 的C语言文件。在文件中编写串口通信程序,例如:
```c
#include <stdio.h>
#include <stdlib.h>
#include <unistd.h>
#include <fcntl.h>
#include <termios.h>
int main() {
int fd;
char buffer[255];
struct termios tty;
fd = open("/dev/ttyUSB0", O_RDWR | O_NOCTTY | O_SYNC);
if (fd < 0) {
printf("Error opening serial port.\n");
return -1;
}
memset(&tty, 0, sizeof(tty));
if (tcgetattr(fd, &tty) != 0) {
printf("Error getting serial port attributes.\n");
return -1;
}
cfsetospeed(&tty, B9600);
cfsetispeed(&tty, B9600);
tty.c_cflag &= ~PARENB;
tty.c_cflag &= ~CSTOPB;
tty.c_cflag &= ~CSIZE;
tty.c_cflag |= CS8;
tty.c_cflag &= ~CRTSCTS;
tty.c_cflag |= CREAD | CLOCAL;
tty.c_iflag &= ~(IXON | IXOFF | IXANY);
tty.c_iflag &= ~(ICANON | ECHO | ECHOE | ISIG);
tty.c_oflag &= ~OPOST;
tty.c_cc[VMIN] = 0;
tty.c_cc[VTIME] = 10;
if (tcsetattr(fd, TCSANOW, &tty) != 0) {
printf("Error setting serial port attributes.\n");
return -1;
}
while (1) {
memset(buffer, 0, sizeof(buffer));
int n = read(fd, buffer, sizeof(buffer));
if (n > 0) {
printf("Received: %s\n", buffer);
}
}
close(fd);
return 0;
}
```
5. 编译程序:在终端输入命令 `gcc -o serial serial.c`,编译程序。
6. 运行程序:在终端输入命令 `sudo ./serial`,运行程序并进行串口通信测试。注意,程序运行后会一直等待串口接收数据,可以通过发送数据给串口来测试程序是否正常接收数据。
以上就是在Ubuntu下编写C语言串口通信并验证的步骤。