arduino电位器控制舵机然后光敏电阻控制灯带的代码

好的，以下是Arduino电位器控制舵机然后光敏电阻控制灯带的代码示例。请将舵机和光敏电阻连接到Arduino的相应引脚，然后上传以下代码：

#include <Servo.h>

Servo myservo;  // create servo object to control a servo
int potpin = 0;  // analog pin used to connect the potentiometer
int val;    // variable to read the value from the potentiometer
int ledPin = 9; // LED connected to digital pin 9
int lightVal;  // variable to read the value from the light-dependent resistor

void setup() {
  myservo.attach(3);  // attaches the servo on pin 3 to the servo object
  pinMode(ledPin, OUTPUT); // set the LED pin as an output
  Serial.begin(9600); // initialize serial communication at 9600 bits per second
}

void loop() {
  val = analogRead(potpin);            // read the value from the potentiometer
  val = map(val, 0, 1023, 0, 179);    // scale the value to servo angle range
  myservo.write(val);                 // set the servo position based on the scaled value
  delay(15);                          
  
  lightVal = analogRead(A0);           // read the value from the light-dependent resistor
  if (lightVal < 400) {               // if the light is dim
    digitalWrite(ledPin, HIGH);       // turn on the LED
  } else {                            // if the light is bright
    digitalWrite(ledPin, LOW);        // turn off the LED
  }
  Serial.println(lightVal);           // print the light value to the serial monitor
  delay(500);                         // wait for half a second
}

这段代码会从电位器读取模拟值，并将其映射到舵机的角度范围内。然后，代码会从光敏电阻读取模拟值，并根据光线的强度控制LED灯带的亮度。在代码中，我将LED连接到数字引脚9，您可以根据需要更改此引脚。