stm32串口程序
时间: 2023-07-24 08:19:14 浏览: 44
以下是一个简单的STM32串口程序的示例:
```
#include "stm32f4xx.h"
/* 定义波特率为115200 */
#define BAUDRATE 115200
/* 初始化串口1 */
void USART1_Init(void)
{
/* 使能USART1和GPIOA的时钟 */
RCC_AHB1PeriphClockCmd(RCC_AHB1Periph_GPIOA, ENABLE);
RCC_APB2PeriphClockCmd(RCC_APB2Periph_USART1, ENABLE);
/* 配置PA9为复用功能 */
GPIO_InitTypeDef GPIO_InitStructure;
GPIO_InitStructure.GPIO_Pin = GPIO_Pin_9;
GPIO_InitStructure.GPIO_Mode = GPIO_Mode_AF;
GPIO_InitStructure.GPIO_Speed = GPIO_Speed_50MHz;
GPIO_InitStructure.GPIO_OType = GPIO_OType_PP;
GPIO_InitStructure.GPIO_PuPd = GPIO_PuPd_UP;
GPIO_Init(GPIOA, &GPIO_InitStructure);
/* 将PA9与USART1的Tx引脚进行连接 */
GPIO_PinAFConfig(GPIOA, GPIO_PinSource9, GPIO_AF_USART1);
/* 配置USART1 */
USART_InitTypeDef USART_InitStructure;
USART_InitStructure.USART_BaudRate = BAUDRATE;
USART_InitStructure.USART_WordLength = USART_WordLength_8b;
USART_InitStructure.USART_StopBits = USART_StopBits_1;
USART_InitStructure.USART_Parity = USART_Parity_No;
USART_InitStructure.USART_HardwareFlowControl = USART_HardwareFlowControl_None;
USART_InitStructure.USART_Mode = USART_Mode_Tx;
USART_Init(USART1, &USART_InitStructure);
/* 使能USART1 */
USART_Cmd(USART1, ENABLE);
}
/* 发送一个字节到串口1 */
void USART1_SendByte(uint8_t byte)
{
/* 等待发送缓冲区为空 */
while (USART_GetFlagStatus(USART1, USART_FLAG_TXE) == RESET);
/* 发送一个字节 */
USART_SendData(USART1, byte);
}
```
在上面的例子中,首先定义了一个波特率常量,然后编写了一个初始化串口1的函数 `USART1_Init()`,该函数会初始化GPIOA的引脚PA9为复用功能,并将其连接到USART1的Tx引脚上。然后使用USART_InitStructure结构体配置USART1,最后使能USART1。
还编写了一个发送单个字节到串口1的函数`USART1_SendByte()`,该函数会等待发送缓冲区为空,然后将字节发送到USART1。