STM32单片机如何控制HC-05蓝牙模块
时间: 2023-11-24 09:05:41 浏览: 40
STM32单片机可以通过串口通信控制HC-05蓝牙模块。
具体步骤如下:
1. 在STM32单片机上配置串口,设置波特率、数据位、停止位等参数。
2. 将HC-05蓝牙模块与STM32单片机通过串口连接。
3. 在STM32单片机上编写程序,通过串口发送AT指令控制HC-05蓝牙模块。
4. HC-05蓝牙模块收到指令后执行相应的操作,比如连接蓝牙设备、发送数据等。
下面是一个简单的示例代码:
#include "stm32f10x.h"
#include "stdio.h"
void USART1_Config(void)
{
GPIO_InitTypeDef GPIO_InitStructure;
USART_InitTypeDef USART_InitStructure;
RCC_APB2PeriphClockCmd(RCC_APB2Periph_GPIOA | RCC_APB2Periph_USART1, ENABLE);
GPIO_InitStructure.GPIO_Pin = GPIO_Pin_9;
GPIO_InitStructure.GPIO_Speed = GPIO_Speed_50MHz;
GPIO_InitStructure.GPIO_Mode = GPIO_Mode_AF_PP;
GPIO_Init(GPIOA, &GPIO_InitStructure);
GPIO_InitStructure.GPIO_Pin = GPIO_Pin_10;
GPIO_InitStructure.GPIO_Mode = GPIO_Mode_IN_FLOATING;
GPIO_Init(GPIOA, &GPIO_InitStructure);
USART_InitStructure.USART_BaudRate = 9600;
USART_InitStructure.USART_WordLength = USART_WordLength_8b;
USART_InitStructure.USART_StopBits = USART_StopBits_1;
USART_InitStructure.USART_Parity = USART_Parity_No;
USART_InitStructure.USART_HardwareFlowControl = USART_HardwareFlowControl_None;
USART_InitStructure.USART_Mode = USART_Mode_Rx | USART_Mode_Tx;
USART_Init(USART1, &USART_InitStructure);
USART_Cmd(USART1, ENABLE);
}
void USART1_SendChar(char ch)
{
while (USART_GetFlagStatus(USART1, USART_FLAG_TC) == RESET);
USART_SendData(USART1, (uint8_t)ch);
}
void USART1_SendString(char* str)
{
while (*str)
{
USART1_SendChar(*str++);
}
}
int main(void)
{
USART1_Config();
// 发送AT指令,查询HC-05蓝牙模块名称
USART1_SendString("AT+NAME?\r\n");
while (1)
{
}
}