ethtool怎么查看网卡是电口还是光口
时间: 2023-03-30 15:00:48 浏览: 418
可以使用命令"ethtool -i eth"来查看网卡的驱动信息,其中"bus-info"一项可以显示网卡的接口类型,如果是"pci:000:xx:xx.x",则是电口;如果是"pci:000:xx:xx.x",则是光口。
相关问题
ethtool查看网卡详情
要查看网卡的详细信息,可以使用ethtool命令。以下是使用ethtool命令查看网卡详情的步骤:
1. 打开终端。
2. 输入以下命令以查看可用的网卡:
```
sudo ifconfig
```
3. 选择要查看详细信息的网卡,然后输入以下命令:
```
sudo ethtool <interface>
```
其中,<interface>是要查看详细信息的网卡的名称,例如eth0。
4. 执行命令后,将显示网卡的详细信息,例如:
```
Settings for eth0:
Supported ports: [ TP ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Supported pause frame use: Symmetric Receive-only
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Advertised pause frame use: Symmetric Receive-only
Advertised auto-negotiation: Yes
Speed: 1000Mb/s
Duplex: Full
Port: Twisted Pair
PHYAD: 1
Transceiver: internal
Auto-negotiation: on
MDI-X: Unknown (auto)
Supports Wake-on: pumbg
Wake-on: g
Current message level: 0x00000007 (7)
drv probe link
Link detected: yes
```
此命令将显示支持的端口和链路模式,支持的暂停帧使用情况,是否支持自动协商,以及当前网卡的速度,双工模式,端口类型和链接检测状态等详细信息。
用ethtool设置网卡
可以使用ethtool命令设置和更改以太网适配器的参数。以下是一些常用的命令示例:
1. 查看以太网适配器的状态和速度:
```
ethtool eth0
```
2. 设置以太网适配器的速度和双工模式:
```
ethtool -s eth0 speed 100 duplex full
```
3. 开启或关闭以太网适配器的自适应性:
```
ethtool -s eth0 autoneg on
ethtool -s eth0 autoneg off
```
4. 更改以太网适配器的MAC地址:
```
ethtool -s eth0 hw ether 00:11:22:33:44:55
```
需要注意的是,ethtool命令的使用可能因系统版本、硬件类型和驱动程序的不同而有所差异。在使用前请先查看相关文档和手册。同时,使用ethtool命令对网卡进行配置需要具有root权限。