实现stm32按键第一下led亮再按一下灭的代码
时间: 2024-03-09 13:51:24 浏览: 36
好的,以下是实现STM32按一下亮再按一下灭LED的代码:
```
#include "stm32f10x.h"
int main(void)
{
//使能GPIOA时钟
RCC_APB2PeriphClockCmd(RCC_APB2Periph_GPIOA, ENABLE);
//配置PA0和PA5引脚
GPIO_InitTypeDef GPIO_InitStructure;
GPIO_InitStructure.GPIO_Pin = GPIO_Pin_0;
GPIO_InitStructure.GPIO_Mode = GPIO_Mode_IPD;
GPIO_InitStructure.GPIO_Speed = GPIO_Speed_50MHz;
GPIO_Init(GPIOA, &GPIO_InitStructure);
GPIO_InitStructure.GPIO_Pin = GPIO_Pin_5;
GPIO_InitStructure.GPIO_Mode = GPIO_Mode_Out_PP;
GPIO_InitStructure.GPIO_Speed = GPIO_Speed_50MHz;
GPIO_Init(GPIOA, &GPIO_InitStructure);
int ledState = 0; //LED状态,0表示灭,1表示亮
while (1)
{
//检测按键状态
if (GPIO_ReadInputDataBit(GPIOA, GPIO_Pin_0) == 0)
{
//等待按键释放
while (GPIO_ReadInputDataBit(GPIOA, GPIO_Pin_0) == 0);
//改变LED状态
ledState = !ledState;
GPIO_WriteBit(GPIOA, GPIO_Pin_5, ledState ? Bit_SET : Bit_RESET);
}
}
}
```
在这个代码中,我们使用了PA5引脚控制LED的亮灭,PA0引脚接按键。在主函数中,我们首先使能了GPIOA的时钟,然后配置了PA0和PA5引脚的工作模式。接着进入了一个死循环,在循环中不断检测PA0引脚的状态,如果检测到按键被按下,则改变LED的状态,从而实现LED的亮灭控制。注意,在检测到按键被按下后,需要等待按键释放,否则会出现多次切换LED状态的问题。