DS2782
6 of 28
DETAILED DESCRIPTION
The DS2782 operates directly from 2.5V to 4.5V and supports single cell Lithium-ion battery packs. As shown in
Figure 3, the DS2782 accommodates multicell applications by adding a voltage regulator for VDD and voltage
divider for VIN. Nonvolatile storage is provided for cell compensation and application parameters. Host side
development of fuel-gauging algorithms is eliminated. On-chip algorithms and convenient status reporting of
operating conditions reduce the serial polling required of the host processor.
Additionally, 16 bytes of EEPROM memory are made available for the exclusive use of the host system and/or
pack manufacturer. The additional EEPROM memory can be used to facilitate battery lot and date tracking and NV
storage of system or battery usage statistics.
Through its 2-Wire interface, the DS2782 gives the host system read/write access to status and control registers,
instrumentation registers, and general-purpose data storage. The 7-bit slave address is field programmable, thus
allowing up to 128 devices to be distinctly addressed by the host system. A unique, factory programmed 64-bit
registration number (8-bit family code + 48-bit serial number + 8-bit CRC) option assures that no two parts are alike
and enables absolute traceability.
Figure 3. Multicell Application Example
SDA
VDD
SNS VSS
RSNS
Pack-
Pack+
SDA
Protection
Circuit
PIO
150
150
SCL
Multi-Cell
Li-Ion
Battery
0.1uF
NC
VIN
(n-1)
*R
(1) (1)
(1) Components improve IEC1004 Air/Contact ESD compliance
n = number of cells used in the application
R resistors should be selected based on the minimum acceptable resistance (highest acceptable current drain) for the application
4.7uF0.1uF
R
500
SCL