没有合适的资源?快使用搜索试试~ 我知道了~
首页CCNA第二学期期末汇总参考答案
资源详情
资源评论
资源推荐
CCNA 2 - Module 1
If a router cannot find a valid configuration file during the startup sequence, what will occur?
The router will prompt the user for a response to enter setup mode.
Refer to the exhibit. The network administrator has configured the router with the interface IP
addresses shown for the directly connected networks. Pings from the router to hosts on the connected
networks or pings between router interfaces are not working. What is the most likely problem?
The interfaces must be enabled with the no shutdown command.
Refer to the exhibit. What can be concluded from the routing table output in the exhibit? (Choose two.)
The FastEthernet0/0 and Serial0/0/0 interfaces of this router were configured with an IP address
and the no shutdown command.
An IP packet received by this router with a destination address of 198.18.9.1 will be forwarded
out of the Serial0/0/0 interface.
Refer to the exhibit. The frame shown in the exhibit was received by the router. The router interfaces
are operational. How will the router process this frame? (Choose two.)
The router will change the frame type to one supported by the WAN link before forwarding the
frame.
The frame was received on the Fa0/0 interface of the router and will be switched to the S0/0/0
interface.
Passwords can be used to restrict access to all or parts of the Cisco IOS. Select the modes and
interfaces that can be protected with passwords. (Choose three.)
VTY interface
console interface
privileged EXEC mode
Which two statements correctly describe the components of a router? (Choose two.)
ROM contains diagnostics executed on hardware modules.
Flash memory does not lose its contents during a reboot.
Refer to the exhibit. After host 2 is connected to the switch on the LAN, host 2 is unable to
communicate with host 1. What is the cause of this problem?
The subnet mask of host 2 is incorrect.
Host 1 and host 2 are on different networks.
The switch needs an IP address that is not configured.
The router LAN interface and host 1 are on different networks.
The IP address of host 1 is on a different network than is the LAN interface of the router.
Which are functions of a router? (Choose three.)
packet switching
segmentation of broadcast domains
selection of best path based on logical addressing
Refer to the exhibit. All routers have a route in its routing table to each network that is shown in the
exhibit. Default routes have not been issued on these routers. What can be concluded about how
packets are forwarded in this network? (Choose two.)
If RouterA receives a packet that is destined for 192.168.3.146, it will be forwarded out interface
S0/0/1.
If RouterB receives a packet that is destined for 10.5.27.15, it will be forwarded out interface
S0/0/1.
The serial connection shown in the graphic needs to be configured. Which configuration commands
must be made on the Sydney router to establish connectivity with the Melbourne site? (Choose three.)
Sydney(config-if)# ip address 201.100.53.2 255.255.255.0
Sydney(config-if)# no shutdown
Sydney(config-if)# clock rate 56000
Refer to the exhibit. What can be concluded from the output of the running-configuration of a router?
The commands that are displayed determine the current operation of the router.
Refer to the exhibit. Host A pings host B. When R4 accepts the ping into the Ethernet interface, what
two pieces of header information are included? (Choose two.)
destination IP address: 192.168.10.134
destination MAC address: 9999.DADC.1234
What is the outcome of entering these commands?
R1(config)# line vty 0 4
R1(config-line)# password check123
R1(config-line)# login
sets the password to be used for connecting to this router via Telnet
Which of the following is the correct flow of routines for a router startup?
load bootstrap, load IOS, apply configuration
What three processes does a router execute when it receives a packet from one network that is destined
for another network? (Choose three.)
decapsulates the Layer 3 packet by stripping off the Layer 2 frame header
uses the destination IP Address in the IP header to look up the next-hop address in the routing
table
encapsulates the Layer 3 packet into the new Layer 2 frame and forwards it out the exit interface
The network administrator needs to connect two routers directly via their FastEthernet ports. What
cable should the network administrator use?
cross-over
Which two statements describe characteristics of load balancing? (Choose two.)
Load balancing allows a router to forward packets over multiple paths to the same destination
network.
Unequal cost load balancing is supported by EIGRP.
What information about the router and its startup process can be gathered from the output of the show
version command? (Choose three.)
the last restart method
the configuration register settings
the location from where the IOS loaded
Which interfaces in the exhibit could be used for a leased line WAN connection? (Choose two.)
1
4
From what location can a router load the Cisco IOS during the boot process? (Choose two.)
TFTP server
Flash memory
A network administrator has just entered new configurations into Router1. Which command should be
executed to save configuration changes to NVRAM?
Router1# copy running-config startup-config
What is the default sequence for loading the configuration file?
NVRAM, TFTP, CONSOLE
What header address information does a router change in the information it receives from an attached
Ethernet interface before information is transmitted out another interface?
the Layer 2 source and destination address
CCNA 2 - Module 2
!"
#$
%&'(
)
*&'(+
$
,!"
!
(&&&&'-$(./(01&/(2/(0-(/
"#$%& !!!!'((!!! )' *+!'
"#$%& !!!!'((!!! ,' *- '
,$
#$(&((&'/1
(&(/&'/1%
#$
. "#$%& ! !'(('(('((! ,' *-!'.'"#$%&
! '!'(('(('((! ,' *-!
3(
,4(./(0&&$
)' *!!'(('((!!/!0!0!
Which address can be used to summarize networks 172.16.0.0/24 thru 172.16.7.0/24?
)' *!!0'
3'-(&&&&
$
1 !!!!
,5
/203/2
,$()
(2/(0-&&/66/66/66&*&'('&($
(2/(0-&//'/1,33
+($
4
/!0 0!
1
7"
56.315
剩余31页未读,继续阅读
Canolai
- 粉丝: 2
- 资源: 10
上传资源 快速赚钱
- 我的内容管理 收起
- 我的资源 快来上传第一个资源
- 我的收益 登录查看自己的收益
- 我的积分 登录查看自己的积分
- 我的C币 登录后查看C币余额
- 我的收藏
- 我的下载
- 下载帮助
会员权益专享
最新资源
- RTL8188FU-Linux-v5.7.4.2-36687.20200602.tar(20765).gz
- c++校园超市商品信息管理系统课程设计说明书(含源代码) (2).pdf
- 建筑供配电系统相关课件.pptx
- 企业管理规章制度及管理模式.doc
- vb打开摄像头.doc
- 云计算-可信计算中认证协议改进方案.pdf
- [详细完整版]单片机编程4.ppt
- c语言常用算法.pdf
- c++经典程序代码大全.pdf
- 单片机数字时钟资料.doc
- 11项目管理前沿1.0.pptx
- 基于ssm的“魅力”繁峙宣传网站的设计与实现论文.doc
- 智慧交通综合解决方案.pptx
- 建筑防潮设计-PowerPointPresentati.pptx
- SPC统计过程控制程序.pptx
- SPC统计方法基础知识.pptx
资源上传下载、课程学习等过程中有任何疑问或建议,欢迎提出宝贵意见哦~我们会及时处理!
点击此处反馈
安全验证
文档复制为VIP权益,开通VIP直接复制
信息提交成功
评论0