粘贴板 编写程序实现： 获取温度，当温度超过26摄氏度后，蜂鸣 器报警，同时红色LED灯闪烁

要实现这个功能，你需要一个硬件设备，比如包含一个温度传感器（例如DS18B20）、一个蜂鸣器和一个红色LED的电路，以及一个编程平台，如Arduino或Raspberry Pi。这里提供一个基本的Arduino C++示例代码，假设你已经将温度传感器连接到数字口和蜂鸣器及LED连接了对应的引脚：

#include <OneWire.h> // For OneWire library (if using DS18B20)
#include <DallasTemperature.h> // For DallasTemperature library
#include <PinChangeInt.h> // For LED flashing on pin change

// Replace these pins with your actual hardware connections
const int tempSensorPin = D4; // DS18B20 data line
const int ledPin = 9; // Red LED
const int buzzerPin = 10; // Buzzer

 DallasTemperature ds; // Create a DallasTemperature object
 PinChangeInterrupt ledInt(ledPin); // Create an interrupt for LED

void setup() {
  Serial.begin(9600);
  ds.begin(); // Initialize the OneWire bus
  pinMode(buzzerPin, OUTPUT); // Set buzzer as output
}

void loop() {
  float temperature;
  
  // Read temperature from DS18B20
  ds.requestTemperatures();
  temperature = ds.getTempCByIndex(0); // Assuming you have only one sensor
  
  // Check if temperature exceeds 26°C
  if (temperature > 26) {
    digitalWrite(buzzerPin, HIGH); // Turn on buzzer
    ledInt.attach ledPin; // Start flashing LED
    delay(500); // Short delay before checking again
    digitalWrite(buzzerPin, LOW); // Turn off buzzer
    ledInt.detach ledPin; // Stop flashing LED
  }

  // Print temperature for debugging
  Serial.print("Temperature: ");
  Serial.println(temperature, 1);

  delay(1000); // Sleep for a second before checking again
}