使用串口通信的工程,用PA9 接TXD PA10接RXD 请写出初始化程序
时间: 2024-02-29 16:52:18 浏览: 18
以下是使用PA9和PA10进行串口通信的STM32工程初始化程序:
```c
#include "stm32f10x.h"
void USART_Configuration(void);
int main(void)
{
USART_Configuration();
while(1)
{
// 在此处编写串口通信程序
}
}
void USART_Configuration(void)
{
GPIO_InitTypeDef GPIO_InitStructure;
USART_InitTypeDef USART_InitStructure;
RCC_APB2PeriphClockCmd(RCC_APB2Periph_GPIOA | RCC_APB2Periph_USART1, ENABLE);
GPIO_InitStructure.GPIO_Pin = GPIO_Pin_9;
GPIO_InitStructure.GPIO_Speed = GPIO_Speed_50MHz;
GPIO_InitStructure.GPIO_Mode = GPIO_Mode_AF_PP;
GPIO_Init(GPIOA, &GPIO_InitStructure);
GPIO_InitStructure.GPIO_Pin = GPIO_Pin_10;
GPIO_InitStructure.GPIO_Mode = GPIO_Mode_IN_FLOATING;
GPIO_Init(GPIOA, &GPIO_InitStructure);
USART_InitStructure.USART_BaudRate = 115200;
USART_InitStructure.USART_WordLength = USART_WordLength_8b;
USART_InitStructure.USART_StopBits = USART_StopBits_1;
USART_InitStructure.USART_Parity = USART_Parity_No;
USART_InitStructure.USART_HardwareFlowControl = USART_HardwareFlowControl_None;
USART_InitStructure.USART_Mode = USART_Mode_Rx | USART_Mode_Tx;
USART_Init(USART1, &USART_InitStructure);
USART_Cmd(USART1, ENABLE);
}
```
初始化程序中,首先通过`RCC_APB2PeriphClockCmd`函数使能GPIOA和USART1的时钟,然后依次配置PA9引脚为复用推挽输出模式、PA10引脚为浮空输入模式和USART1的波特率、数据位、停止位、校验位等参数。最后使能USART1,使其可以进行数据收发。
在程序中,可以在`while(1)`循环中编写串口通信程序,例如使用`USART_SendData`函数发送数据,使用`USART_ReceiveData`函数接收数据。注意,在编写串口通信程序时,要根据具体的通信协议选择正确的波特率、数据位、停止位和校验位等参数。