用matlab进行QPSK数字调制输出调制信号、载波信号、已调信号和解调信号的波形和频谱,输出已调信号星座图
时间: 2024-01-16 15:01:48 浏览: 25
以下是使用MATLAB进行QPSK数字调制的示例代码:
```matlab
% 设置参数
fs = 1000; % 采样率
T = 1/fs; % 采样周期
fc = 10; % 载波频率
Ts = 1/fc; % 载波周期
N = 1000; % 信号长度
data = randi([0, 3], 1, N); % 生成随机的0-3之间的整数作为调制数据
% QPSK调制
symbols = exp(1j*(pi/4)*(2*data+1)); % 映射调制数据到星座图上的点
t = (0:N-1)*T; % 时间序列
carrier = cos(2*pi*fc*t); % 载波信号
modulated_signal = real(symbols.*carrier); % 已调信号
% 解调
demodulated_signal = modulated_signal.*carrier; % 解调信号
% 绘制波形和频谱
figure;
subplot(2, 2, 1);
plot(t, symbols, 'o');
title('已调信号星座图');
xlabel('I');
ylabel('Q');
subplot(2, 2, 2);
plot(t, carrier);
title('载波信号');
xlabel('时间');
ylabel('幅度');
subplot(2, 2, 3);
plot(t, modulated_signal);
title('已调信号波形');
xlabel('时间');
ylabel('幅度');
subplot(2, 2, 4);
f = (-N/2:N/2-1)*(fs/N);
spectrum = abs(fftshift(fft(modulated_signal)));
plot(f, spectrum);
title('已调信号频谱');
xlabel('频率');
ylabel('幅度');
```