arduino实现ota
时间: 2023-10-06 11:08:09 浏览: 68
OTA(Over-The-Air)是一种无需通过物理连接,而是通过网络进行固件升级的方式。在Arduino中,可以通过ESP8266或ESP32模块来实现OTA功能。
以下是实现OTA的基本步骤:
1. 首先,需要在Arduino IDE中安装ESP8266或ESP32的板卡支持库。
2. 在Arduino代码中添加OTA库的头文件和OTA回调函数,如下所示:
```
#include <ESP8266WiFi.h>
#include <ESP8266mDNS.h>
#include <WiFiUdp.h>
#include <ArduinoOTA.h>
void setup() {
// Connect to WiFi network
WiFi.mode(WIFI_STA);
WiFi.begin(ssid, password);
while (WiFi.waitForConnectResult() != WL_CONNECTED) {
Serial.println("Connection Failed! Rebooting...");
delay(5000);
ESP.restart();
}
// Configure OTA Updates
ArduinoOTA.setHostname(hostName);
ArduinoOTA.setPassword(otaPassword);
ArduinoOTA.onStart([]() {
String type;
if (ArduinoOTA.getCommand() == U_FLASH)
type = "sketch";
else // U_SPIFFS
type = "filesystem";
// NOTE: if updating SPIFFS this would be the place to unmount SPIFFS using SPIFFS.end()
Serial.println("Start updating " + type);
});
ArduinoOTA.onEnd([]() {
Serial.println("\nEnd");
});
ArduinoOTA.onProgress([](unsigned int progress, unsigned int total) {
Serial.printf("Progress: %u%%\r", (progress / (total / 100)));
});
ArduinoOTA.onError([](ota_error_t error) {
Serial.printf("Error[%u]: ", error);
if (error == OTA_AUTH_ERROR) Serial.println("Auth Failed");
else if (error == OTA_BEGIN_ERROR) Serial.println("Begin Failed");
else if (error == OTA_CONNECT_ERROR) Serial.println("Connect Failed");
else if (error == OTA_RECEIVE_ERROR) Serial.println("Receive Failed");
else if (error == OTA_END_ERROR) Serial.println("End Failed");
});
ArduinoOTA.begin();
}
```
3. 添加OTA功能的主循环代码:
```
void loop() {
ArduinoOTA.handle();
// your normal code goes here
}
```
4. 在Arduino IDE中,选择“Sketch”->“Export Compiled Binary”生成.bin文件,然后上传到OTA服务器。
5. 使用OTA客户端软件,如“ESP8266Flasher”或“ESP32Flasher”,将.bin文件上传到OTA服务器。
6. 执行OTA升级操作,等待固件升级完成。
以上是实现Arduino OTA的基本步骤,具体细节和配置可以根据实际情况进行调整。