stm32串口接收函数查询方式
时间: 2023-11-15 12:04:09 浏览: 38
在STM32中,串口接收数据可以使用中断或者轮询方式。下面分别介绍这两种方法的查询方式:
1. 中断方式
在使用中断方式时,需要先配置串口接收中断。以USART1为例:
```c
// 使能USART1的中断
HAL_NVIC_SetPriority(USART1_IRQn, 0, 1);
HAL_NVIC_EnableIRQ(USART1_IRQn);
// 配置USART1接收中断
__HAL_UART_ENABLE_IT(&huart1, UART_IT_RXNE);
```
然后在中断服务函数中读取接收到的数据:
```c
void USART1_IRQHandler(void)
{
uint32_t isrflags = READ_REG(huart1.Instance->SR);
uint32_t cr1its = READ_REG(huart1.Instance->CR1);
uint32_t cr3its = READ_REG(huart1.Instance->CR3);
uint32_t errorflags;
if (((isrflags & USART_SR_RXNE) != RESET) && ((cr1its & USART_CR1_RXNEIE) != RESET))
{
if ((isrflags & USART_SR_PE) == RESET)
{
// 无奇偶校验错误
if ((isrflags & USART_SR_ORE) == RESET)
{
// 无溢出错误
uint8_t data = (uint8_t)(huart1.Instance->DR & (uint8_t)0xFF);
// 处理接收到的数据
}
else
{
// 处理接收溢出错误
}
}
else
{
// 处理奇偶校验错误
}
}
// 其他中断处理
}
```
2. 轮询方式
在使用轮询方式时,直接读取USART_DR寄存器即可获取接收到的数据。例如:
```c
while (1)
{
if (__HAL_UART_GET_FLAG(&huart1, UART_FLAG_RXNE) != RESET)
{
uint8_t data = (uint8_t)(huart1.Instance->DR & (uint8_t)0xFF);
// 处理接收到的数据
}
}
```
以上是两种查询方式,可以根据实际情况选择使用。