写wb2812灯珠驱动,引脚位置为GPIOA13,
时间: 2024-03-12 16:49:04 浏览: 16
好的,以下是一个基于STM32的WB2812灯珠驱动代码,引脚位置为GPIOA13:
```c
#include "stm32f10x.h"
#define LED_NUM 8 // 灯珠数量
#define LED_PIN GPIO_Pin_13 // 引脚号
#define LED_PORT GPIOA // 引脚所在的GPIO端口
// 发送一个bit
void sendBit(uint8_t bit) {
if (bit) {
GPIO_SetBits(LED_PORT, LED_PIN);
// 延时一段时间
for (int i = 0; i < 10; i++);
GPIO_ResetBits(LED_PORT, LED_PIN);
// 延时一段时间
for (int i = 0; i < 20; i++);
} else {
GPIO_SetBits(LED_PORT, LED_PIN);
// 延时一段时间
for (int i = 0; i < 20; i++);
GPIO_ResetBits(LED_PORT, LED_PIN);
// 延时一段时间
for (int i = 0; i < 10; i++);
}
}
// 发送一个字节
void sendByte(uint8_t byte) {
for (int i = 0; i < 8; i++) {
sendBit(byte & 0x80);
byte <<= 1;
}
}
// 发送一组RGB数据
void sendColor(uint8_t r, uint8_t g, uint8_t b) {
sendByte(g);
sendByte(r);
sendByte(b);
}
int main(void) {
// 初始化GPIO
GPIO_InitTypeDef GPIO_InitStructure;
RCC_APB2PeriphClockCmd(RCC_APB2Periph_GPIOA, ENABLE);
GPIO_InitStructure.GPIO_Pin = LED_PIN;
GPIO_InitStructure.GPIO_Mode = GPIO_Mode_Out_PP;
GPIO_InitStructure.GPIO_Speed = GPIO_Speed_50MHz;
GPIO_Init(LED_PORT, &GPIO_InitStructure);
// 发送灯光数据
while (1) {
for (int i = 0; i < LED_NUM; i++) {
sendColor(255, 0, 0); // 红色
}
}
}
```
这个代码中,使用了两个函数`sendBit`和`sendByte`来发送数据。在`sendBit`函数中,我们根据要发送的bit来判断发送时间的长短,然后分别进行高电平和低电平的控制。在`sendByte`函数中,我们通过循环调用`sendBit`函数来发送一个字节的数据。最后,我们通过调用`sendColor`函数来发送一组RGB数据。