stm32串口初始化步骤
时间: 2023-09-14 21:07:44 浏览: 60
下面是STM32串口初始化步骤:
1. 配置GPIO引脚为串口功能,选择对应的串口编号(如USART1、USART2等)。
2. 配置USART寄存器,包括波特率、数据位、停止位、校验位等。
3. 使能USART时钟。
4. 使能USART模块。
5. 配置中断(可选),如果需要使用中断方式来处理数据传输。
下面是一个示例代码,初始化USART1,波特率为9600,8位数据位,1位停止位,无校验位,不使用中断。
```c
// 配置PA9为USART1_TX,PA10为USART1_RX
GPIO_InitTypeDef GPIO_InitStructure;
USART_InitTypeDef USART_InitStructure;
RCC_APB2PeriphClockCmd(RCC_APB2Periph_GPIOA, ENABLE);
RCC_APB2PeriphClockCmd(RCC_APB2Periph_USART1, ENABLE);
GPIO_InitStructure.GPIO_Pin = GPIO_Pin_9;
GPIO_InitStructure.GPIO_Mode = GPIO_Mode_AF_PP;
GPIO_InitStructure.GPIO_Speed = GPIO_Speed_50MHz;
GPIO_Init(GPIOA, &GPIO_InitStructure);
GPIO_InitStructure.GPIO_Pin = GPIO_Pin_10;
GPIO_InitStructure.GPIO_Mode = GPIO_Mode_IN_FLOATING;
GPIO_Init(GPIOA, &GPIO_InitStructure);
USART_InitStructure.USART_BaudRate = 9600;
USART_InitStructure.USART_WordLength = USART_WordLength_8b;
USART_InitStructure.USART_StopBits = USART_StopBits_1;
USART_InitStructure.USART_Parity = USART_Parity_No;
USART_InitStructure.USART_HardwareFlowControl = USART_HardwareFlowControl_None;
USART_InitStructure.USART_Mode = USART_Mode_Rx | USART_Mode_Tx;
USART_Init(USART1, &USART_InitStructure);
USART_Cmd(USART1, ENABLE);
```