示例
以下示例显示了对 FC_switch_A_1 执行的命令:
FC_switch_A_1# setup
Congure read-only SNMP community string (yes/no) [n]: y
SNMP community string : public
Note: Please set the SNMP community string to "Public" or another
value of your choosing.
Congure default switchport interface state (shut/noshut) [shut]: noshut
Congure default switchport port mode F (yes/no) [n]: n
Congure default zone policy (permit/deny) [deny]: deny
Enable full zoneset distribution? (yes/no) [n]: yes
以下示例显示了对 FC_switch_B_1 执行的命令:
FC_switch_B_1# setup
Congure read-only SNMP community string (yes/no) [n]: y
SNMP community string : public
Note: Please set the SNMP community string to "Public" or another
value of your choosing.
Congure default switchport interface state (shut/noshut) [shut]: noshut
Congure default switchport port mode F (yes/no) [n]: n
Congure default zone policy (permit/deny) [deny]: deny
Enable full zoneset distribution? (yes/no) [n]: yes
获取端口许可证
您无需在一系列连续的端口上使用 Cisco 交换机许可证,而是可以为正在使用的特定端口
获取许可证,并从未使用的端口中删除许可证。您应对交换机配置中已获许可的端口数量
进行验证,如有必要,还可以根据需要将一个端口的许可证移到另一个端口。
步骤
1. 发出以下命令,显示交换机网络结构的许可证使用情况:show port-resources
module 1
确定哪些端口需要许可证。如果这些端口中有部分端口未获许可,请确定已获许可
的端口是否多余,并考虑删除这些端口的许可证。
2. 发出以下命令,进入配置模式:config t