IQ-View_MTK_ATE测试命令

1

ATE TEST PLAIN

Prepare Equipment and Set-Up

1. Please prepare a PC which is used to install IQ-View controller function

2. IQ-View.

Set-up IQ-View

Select the IQ-Signal for MIMO

2

3

Start To Test

Test 1:

Object:

Simulate the packets.

ATE Command:

iwpriv ra0 set ATE=ATESTART

iwpriv ra0 set ATETXMODE=1

iwpriv ra0 set ATETXMCS=7

iwpriv ra0 set ATETXBW=0

iwpriv ra0 set ATETXGI=0

Result:

Please check the picture of IQ-View will like the Fig 1.

Fig.1

4

Test Channel Switching Function

ATE Command:

Please use the ATE command listed in Step 1 and change “iwpriv ra0 set

ATECHANNEL=xx” to test all channel (xx is decimal and should be from 1 to 14 for G

and 35 to 164 for A)

Result:

Test 3:

Object

Test Frequency Offset

iwpriv ra0 set ATETXGI=0

iwpriv ra0 set ATETXFREQOFFSET=10

iwpriv ra0 set ATETXPOW0=15

iwpriv ra0 set ATETXCNT=0

iwpriv ra0 set ATE=TXFRAME

…

iwpriv ra0 set ATETXFREQOFFSET=50

Result

5

Please check the Syn Clk. The value of this parameter will increase/decrease as the

frequency.

iwpriv ra0 set ATE=ATESTART

iwpriv ra0 set ATECHANNEL=1