程序题:编写程序使GPIOA.0和GPIOA.1置位
时间: 2023-03-20 17:02:52 浏览: 198
以下是使用C语言编写程序将GPIOA.0和GPIOA.1置位的示例代码:
```c
#include <stm32f4xx.h> // 引入STM32F4xx库
int main(void) {
// 初始化GPIOA时钟
RCC_AHB1PeriphClockCmd(RCC_AHB1Periph_GPIOA, ENABLE);
// 配置GPIOA.0和GPIOA.1为推挽输出
GPIO_InitTypeDef GPIO_InitStructure;
GPIO_InitStructure.GPIO_Pin = GPIO_Pin_0 | GPIO_Pin_1;
GPIO_InitStructure.GPIO_Mode = GPIO_Mode_OUT;
GPIO_InitStructure.GPIO_OType = GPIO_OType_PP;
GPIO_InitStructure.GPIO_Speed = GPIO_Speed_100MHz;
GPIO_InitStructure.GPIO_PuPd = GPIO_PuPd_NOPULL;
GPIO_Init(GPIOA, &GPIO_InitStructure);
// 置位GPIOA.0和GPIOA.1
GPIO_SetBits(GPIOA, GPIO_Pin_0 | GPIO_Pin_1);
while(1) {
// 程序循环执行
}
}
```
该程序使用STM32F4xx库,通过对GPIOA.0和GPIOA.1进行初始化并将它们置位,可以使这两个引脚输出高电平。程序进入一个无限循环以保持引脚状态。注意,该程序假设你已正确配置了STM32F4xx微控制器的系统时钟和其他必要的设置。