stm32 dht11的代码
时间: 2023-05-24 22:06:51 浏览: 233
以下是一个简单的stm32 dht11代码示例,仅供参考:
```c
#include "stm32f10x.h"
#include "delay.h"
#include "dht11.h"
int main(void)
{
GPIO_InitTypeDef GPIO_InitStructure;
USART_InitTypeDef USART_InitStructure;
RCC_APB2PeriphClockCmd(RCC_APB2Periph_GPIOA | RCC_APB2Periph_USART1, ENABLE); //开启GPIOA和USART1的时钟
//配置USART1
USART_InitStructure.USART_BaudRate = 9600;
USART_InitStructure.USART_WordLength = USART_WordLength_8b;
USART_InitStructure.USART_StopBits = USART_StopBits_1;
USART_InitStructure.USART_Parity = USART_Parity_No;
USART_InitStructure.USART_Mode = USART_Mode_Tx;
USART_InitStructure.USART_HardwareFlowControl = USART_HardwareFlowControl_None;
USART_Init(USART1, &USART_InitStructure);
//配置GPIO,PA4为DHT11数据线
GPIO_InitStructure.GPIO_Pin = GPIO_Pin_4;
GPIO_InitStructure.GPIO_Mode = GPIO_Mode_Out_PP;
GPIO_InitStructure.GPIO_Speed = GPIO_Speed_50MHz;
GPIO_Init(GPIOA, &GPIO_InitStructure);
//初始化DHT11
DHT11_Init();
while (1)
{
uint8_t temperature, humidity; //定义温度和湿度变量
if (DHT11_Read_Data(&temperature, &humidity) == SUCCESS) //成功读取到数据
{
//向串口1输出温湿度值
USART_SendData(USART1, temperature);
delay_us(1000);
USART_SendData(USART1, humidity);
delay_ms(2000);
}
else //未能成功读取到数据
{
USART_SendData(USART1, 'E'); //向串口1输出错误信息
delay_ms(2000);
}
}
}
```
阅读全文