stm32f1串口1配置main函数
时间: 2023-08-13 07:02:42 浏览: 49
当配置 STM32F1 的串口1 时,你需要在 main 函数中进行以下步骤:
1. 首先,确保已经打开了 USART1 的时钟。你可以使用 `RCC_APB2PeriphClockCmd()` 函数来实现,例如:`RCC_APB2PeriphClockCmd(RCC_APB2Periph_USART1, ENABLE);`。
2. 配置 USART1 的引脚。根据你的需求,选择相应的引脚作为 USART1 的 TX 和 RX 引脚,并将它们配置为复用功能。你可以使用 `GPIO_Init()` 函数来实现,例如:
```c
GPIO_InitTypeDef GPIO_InitStructure;
GPIO_InitStructure.GPIO_Pin = GPIO_Pin_9; // USART1 TX 引脚
GPIO_InitStructure.GPIO_Mode = GPIO_Mode_AF_PP; // 复用推挽输出
GPIO_InitStructure.GPIO_Speed = GPIO_Speed_50MHz;
GPIO_Init(GPIOA, &GPIO_InitStructure);
GPIO_InitStructure.GPIO_Pin = GPIO_Pin_10; // USART1 RX 引脚
GPIO_InitStructure.GPIO_Mode = GPIO_Mode_IN_FLOATING; // 浮空输入
GPIO_Init(GPIOA, &GPIO_InitStructure);
```
3. 配置 USART1 的参数,例如波特率、数据位、停止位和校验位等。你可以使用 `USART_Init()` 函数来实现,例如:
```c
USART_InitTypeDef USART_InitStructure;
USART_InitStructure.USART_BaudRate = 115200; // 波特率
USART_InitStructure.USART_WordLength = USART_WordLength_8b; // 数据位为 8 位
USART_InitStructure.USART_StopBits = USART_StopBits_1; // 停止位为 1 位
USART_InitStructure.USART_Parity = USART_Parity_No; // 无校验位
USART_InitStructure.USART_HardwareFlowControl = USART_HardwareFlowControl_None; // 无硬件流控制
USART_InitStructure.USART_Mode = USART_Mode_Rx | USART_Mode_Tx; // 同时接收和发送
USART_Init(USART1, &USART_InitStructure);
```
4. 启用 USART1,你可以使用 `USART_Cmd()` 函数来实现,例如:`USART_Cmd(USART1, ENABLE);`。
至此,你已经完成了串口1的配置。接下来,你可以使用 `USART_SendData()` 和 `USART_ReceiveData()` 函数来发送和接收数据。
注意:以上代码片段仅供参考,具体的配置参数和引脚设置需要根据你的实际需求进行调整。