Page
3-1 11
3-1 11
3-1 11
3-1 12
3-1 17
3-1
18
3-1 20
3-1 20
3-
1
20
3-1 22
Mistake
I
Correction
Change of (2) (e) section
(e) Once the first-point positioning has
started, the next positioning step is
performed if the step start data is set to
01H when the axis operation status is
steD standbv.
.___________-__-__-------------------------
...........................................
(e)
If
the step start information is set to OlH
while the axis run state is the step wait
state, the next positioning step will be
executed.
I
Deletion of (2)
(9
(9
When step operation is performed
-
.-------------------------------------------------------------------------------------
continuously, it is first confirmed that the
step start data is set to OOH (by the
OS),
then the step start data is set to 01H.
Correction of (2) (9) section
(9) Once the first-point positioning has (9) If the step start information is set to 01H
started, the stopped processing of
operation status is step-stopped.
data will be restarted.
data is set to 01H
or
02H when the axis
step stop state, the stopped positioning positioning data restarts if the step start
or
02H while the axis run state is the
.------------------------------------------
..........................................
Correction of (2)
(j)
section
(j)
When the axis operation status is step
(j)
If the positioning start signal is turned
standby, step-stopped,
or
step error with
designated with the positioning start
No.
signal again.
positioning the positioning
No.
upon turning
ON
the positioning start
during a step error, the step for
point positioning step will be performed
valid signal ON, while step stopped
or
the step effective signal ON, the first-
ON again while step waiting for the step
.-------------------------------------------------------------------------------------
will be executed.
Correction of buffer memory address
...
Set
500,
in buffer memory address
1138.
T..,
Set
500,
in buffer memory address
1105.
Correction of buffer memory address
...
Set
600,
in buffer memory address
1138.
.,.
Set
600,
in buffer memory address
1105.
...
Set
500,
in buffer memory address
1138.
...
Set
500,
in buffer memory address
1105.
Addition of explanation to
(2)
(e)
(e) If it is not possible to secure a sufficient
(e)
If
it
is not possible
to
secure a sufficient
distance for this function
to
change the
distance for this function to change the
current speed to the designated override
current speed
to
the designated override
speed, the current speed is changed
to
speed, the current speed is changed
to
the highest possible speed within the
the highest possible speed within the
given distance.
given distance.
.------------------------------------------
..........................................
.-------------------------------------------------------------------------------------
.-------------------------------------------------------------------------------------
However, if the run pattern is the
continuous path control, the speed will
not be changed.
Correction of (2) (h) section
(h) If the feed speed of
1
or
less results from
setting an override value of
100%
or
less,
a warning (warning No.110) occurs, while
the feed is performed at the speed of "1
'I
in the current meed units.
.--_--_-_-------________________________---
address is a ring address between
0
and
address is a ring address between
0
and
360".
359,99999".
-5-