STM32 配置RS485
时间: 2023-07-04 15:07:17 浏览: 156
要在STM32上配置RS485,您需要做以下几步:
1. 配置GPIO口:选择一个GPIO口作为控制RS485芯片使能信号的控制口,将该GPIO口设置为输出模式。
2. 配置USART口:将USART口设置为RS485模式,这可以通过设置USART控制寄存器来完成。在RS485模式下,USART口的发送和接收方向是动态切换的,通过控制GPIO口的使能信号来实现。
3. 设置USART口的波特率、数据位、停止位和校验位等参数。
4. 在发送数据前,将使能信号置高,发送完成后,将使能信号置低。
下面是一个基本的RS485配置代码示例(使用USART1口和PA12口作为使能信号控制口):
```c
#include "stm32f10x.h"
void RS485_Init(void)
{
GPIO_InitTypeDef GPIO_InitStructure;
USART_InitTypeDef USART_InitStructure;
// 配置GPIO口
RCC_APB2PeriphClockCmd(RCC_APB2Periph_GPIOA, ENABLE);
GPIO_InitStructure.GPIO_Pin = GPIO_Pin_12;
GPIO_InitStructure.GPIO_Mode = GPIO_Mode_Out_PP;
GPIO_InitStructure.GPIO_Speed = GPIO_Speed_50MHz;
GPIO_Init(GPIOA, &GPIO_InitStructure);
// 配置USART口
RCC_APB2PeriphClockCmd(RCC_APB2Periph_USART1, ENABLE);
USART_InitStructure.USART_BaudRate = 9600;
USART_InitStructure.USART_WordLength = USART_WordLength_8b;
USART_InitStructure.USART_StopBits = USART_StopBits_1;
USART_InitStructure.USART_Parity = USART_Parity_No;
USART_InitStructure.USART_HardwareFlowControl = USART_HardwareFlowControl_None;
USART_InitStructure.USART_Mode = USART_Mode_Rx | USART_Mode_Tx;
USART_Init(USART1, &USART_InitStructure);
USART_RS485Cmd(USART1, ENABLE); // 设置USART口为RS485模式
// 使能USART
USART_Cmd(USART1, ENABLE);
}
void RS485_SendData(uint8_t* data, uint16_t len)
{
GPIO_SetBits(GPIOA, GPIO_Pin_12); // 置高使能信号
for(uint16_t i=0; i<len; i++)
{
USART_SendData(USART1, data[i]);
while(USART_GetFlagStatus(USART1, USART_FLAG_TXE) == RESET); // 等待发送完成
}
while(USART_GetFlagStatus(USART1, USART_FLAG_TC) == RESET); // 等待发送完成
GPIO_ResetBits(GPIOA, GPIO_Pin_12); // 置低使能信号
}
```
这是一个基础的RS485配置示例,您可以根据自己的需求进行调整。