设计一个stm32f407单片机C程序 ,要求PA5端口的指示灯1秒闪烁一次,使用STM32 HAL函数库
时间: 2024-05-03 11:19:16 浏览: 21
以下是一个简单的C程序,可以让PA5端口的LED指示灯每秒闪烁一次。该程序使用STM32 HAL函数库。
```c
#include "stm32f4xx_hal.h"
int main(void)
{
// 初始化HAL库
HAL_Init();
// 使能GPIOA时钟
__HAL_RCC_GPIOA_CLK_ENABLE();
// 配置PA5引脚为输出模式
GPIO_InitTypeDef GPIO_InitStruct = {0};
GPIO_InitStruct.Pin = GPIO_PIN_5;
GPIO_InitStruct.Mode = GPIO_MODE_OUTPUT_PP;
GPIO_InitStruct.Pull = GPIO_NOPULL;
GPIO_InitStruct.Speed = GPIO_SPEED_FREQ_LOW;
HAL_GPIO_Init(GPIOA, &GPIO_InitStruct);
while (1)
{
// 点亮LED
HAL_GPIO_WritePin(GPIOA, GPIO_PIN_5, GPIO_PIN_SET);
// 延迟500毫秒
HAL_Delay(500);
// 关闭LED
HAL_GPIO_WritePin(GPIOA, GPIO_PIN_5, GPIO_PIN_RESET);
// 延迟500毫秒
HAL_Delay(500);
}
}
```
该程序首先初始化了HAL库,并使能了GPIOA的时钟。然后,将PA5引脚配置为输出模式,并在while循环中反复点亮和关闭LED,每次延迟500毫秒,从而实现了每秒闪烁一次的效果。
相关推荐
![](https://csdnimg.cn/download_wenku/file_type_ask_c1.png)
![](https://csdnimg.cn/download_wenku/file_type_ask_c1.png)
![](https://csdnimg.cn/download_wenku/file_type_ask_c1.png)
![](https://csdnimg.cn/download_wenku/file_type_ask_c1.png)
![](https://csdnimg.cn/download_wenku/file_type_ask_c1.png)
![](https://csdnimg.cn/download_wenku/file_type_ask_c1.png)
![](https://csdnimg.cn/download_wenku/file_type_ask_c1.png)
![](https://csdnimg.cn/download_wenku/file_type_ask_c1.png)
![](https://csdnimg.cn/download_wenku/file_type_ask_c1.png)
![](https://csdnimg.cn/download_wenku/file_type_ask_c1.png)
![](https://csdnimg.cn/download_wenku/file_type_ask_c1.png)
![](https://csdnimg.cn/download_wenku/file_type_ask_c1.png)
![](https://csdnimg.cn/download_wenku/file_type_ask_c1.png)
![](https://csdnimg.cn/download_wenku/file_type_ask_c1.png)
![](https://csdnimg.cn/download_wenku/file_type_ask_c1.png)