STM32F4的PA9PA10连接MAX3490的程序
时间: 2024-02-17 22:01:29 浏览: 33
以下是基于STM32F4的PA9和PA10引脚连接MAX3490的示例程序:
```c
#include "stm32f4xx.h"
#include "stm32f4xx_conf.h"
#define USART_TX_PIN GPIO_Pin_9
#define USART_RX_PIN GPIO_Pin_10
// 初始化USART2
void init_USART2(void) {
USART_InitTypeDef USART_InitStruct;
GPIO_InitTypeDef GPIO_InitStruct;
// 使能GPIOA时钟
RCC_AHB1PeriphClockCmd(RCC_AHB1Periph_GPIOA, ENABLE);
// 使能USART2时钟
RCC_APB1PeriphClockCmd(RCC_APB1Periph_USART2, ENABLE);
// 配置PA9作为USART2的TX引脚
GPIO_InitStruct.GPIO_Pin = USART_TX_PIN;
GPIO_InitStruct.GPIO_Mode = GPIO_Mode_AF;
GPIO_InitStruct.GPIO_Speed = GPIO_Speed_50MHz;
GPIO_InitStruct.GPIO_OType = GPIO_OType_PP;
GPIO_InitStruct.GPIO_PuPd = GPIO_PuPd_UP;
GPIO_Init(GPIOA, &GPIO_InitStruct);
// 配置PA10作为USART2的RX引脚
GPIO_InitStruct.GPIO_Pin = USART_RX_PIN;
GPIO_InitStruct.GPIO_Mode = GPIO_Mode_AF;
GPIO_InitStruct.GPIO_Speed = GPIO_Speed_50MHz;
GPIO_InitStruct.GPIO_OType = GPIO_OType_PP;
GPIO_InitStruct.GPIO_PuPd = GPIO_PuPd_UP;
GPIO_Init(GPIOA, &GPIO_InitStruct);
// 将PA9和PA10引脚连接到USART2的对应引脚上
GPIO_PinAFConfig(GPIOA, GPIO_PinSource9, GPIO_AF_USART2);
GPIO_PinAFConfig(GPIOA, GPIO_PinSource10, GPIO_AF_USART2);
// 配置USART2的参数
USART_InitStruct.USART_BaudRate = 115200;
USART_InitStruct.USART_WordLength = USART_WordLength_8b;
USART_InitStruct.USART_StopBits = USART_StopBits_1;
USART_InitStruct.USART_Parity = USART_Parity_No;
USART_InitStruct.USART_HardwareFlowControl = USART_HardwareFlowControl_None;
USART_InitStruct.USART_Mode = USART_Mode_Rx | USART_Mode_Tx;
USART_Init(USART2, &USART_InitStruct);
// 使能USART2
USART_Cmd(USART2, ENABLE);
}
int main(void) {
init_USART2();
// 下面可以写发送和接收数据的代码
while (1);
return 0;
}
```
上面的代码将PA9和PA10引脚分别连接到USART2的TX和RX引脚上,并配置USART2的参数。可以在初始化之后,通过USART2发送和接收数据。