stm32f103,串口发送字节流程序
时间: 2023-08-01 08:13:45 浏览: 74
下面是一个基本的示例代码,用于在STM32F103芯片上使用串口发送字节流:
```c
#include "stm32f10x.h"
void UART_Configuration(void) {
GPIO_InitTypeDef GPIO_InitStructure;
USART_InitTypeDef USART_InitStructure;
// 使能串口1和对应的GPIO引脚时钟
RCC_APB2PeriphClockCmd(RCC_APB2Periph_USART1 | RCC_APB2Periph_GPIOA, ENABLE);
// 配置USART1的GPIO引脚
GPIO_InitStructure.GPIO_Pin = GPIO_Pin_9; // USART1_TX引脚
GPIO_InitStructure.GPIO_Mode = GPIO_Mode_AF_PP; // 复用推挽输出模式
GPIO_InitStructure.GPIO_Speed = GPIO_Speed_50MHz;
GPIO_Init(GPIOA, &GPIO_InitStructure);
// 配置USART1
USART_InitStructure.USART_BaudRate = 115200; // 波特率为115200bps
USART_InitStructure.USART_WordLength = USART_WordLength_8b; // 数据位长度为8位
USART_InitStructure.USART_StopBits = USART_StopBits_1; // 1个停止位
USART_InitStructure.USART_Parity = USART_Parity_No; // 无奇偶校验
USART_InitStructure.USART_HardwareFlowControl = USART_HardwareFlowControl_None; // 无硬件流控制
USART_InitStructure.USART_Mode = USART_Mode_Tx; // 仅发送模式
USART_Init(USART1, &USART_InitStructure);
// 使能USART1
USART_Cmd(USART1, ENABLE);
}
void USART_SendByte(uint8_t byte) {
// 等待发送缓冲区为空
while (USART_GetFlagStatus(USART1, USART_FLAG_TXE) == RESET);
// 发送字节
USART_SendData(USART1, byte);
}
int main(void) {
// 初始化串口
UART_Configuration();
while (1) {
// 发送字节流
USART_SendByte(0x55);
USART_SendByte(0xAA);
USART_SendByte(0x01);
USART_SendByte(0x02);
// 延时
for (volatile int i = 0; i < 1000000; i++);
}
}
```
这段代码假设你使用的是串口1(USART1)和PA9引脚作为发送引脚。你可以根据需要修改波特率和发送的字节流内容。在主循环中,可以通过多次调用`USART_SendByte`函数来发送字节。请确保使用适当的时钟配置和引脚配置来匹配你的硬件连接。